Scribd
Upload
358 views1 page

Network Configuration Script

The document contains an O&M script that defines the IP configuration and routing for network interfaces. It specifies the default gateway, IP addresses, subnet masks, and VLAN IDs for traffic and O&M interfaces. It also defines NTP servers and static routes through the O&M gateway.

Uploaded by

Rashad Ahmad
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
358 views1 page

Network Configuration Script

The document contains an O&M script that defines the IP configuration and routing for network interfaces. It specifies the default gateway, IP addresses, subnet masks, and VLAN IDs for traffic and O&M interfaces. It also defines NTP servers and static routes through the O&M gateway.

Uploaded by

Rashad Ahmad
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd

O&M Script

<IPoverGigabitEthernet
defaultRouter0="[Link]"
etIPSynchSlot="1"
syncIpAddress="[Link]"
syncSubnetMask="[Link]"
syncVid="3008">

------ Traffic Gateway


------ Traffic IP Address
------ Traffic Subnet
------- Traffic Vlan ID

<IpSyncRef
ntpServerIpAddress="[Link]"
/>
<IpSyncRef
ntpServerIpAddress="[Link]"
/>

------ Syncref

----- Syncref

<OamIpHost
oamDefaultRouter0="[Link]"
-----O&M Gateway
oamIpAddress="[Link]"
------- O&M IP Address
oamSubnetMask="[Link]"
-----O&M Subnet
oamVid="52"
------- O&M Vlan ID
/>
<GigaBitEthernet
gigaBitEthernetPort="TNA"
/>

--------

TNA for RJ45 /// TNB for Fiber

/>
<StaticRouting>
<Route
hopIpAddress="[Link]" ------ O&M Gateway
redistribute="NO"
routeIpAddress="[Link]"
routeMetric="10"
routeSubnetMask="[Link]"

You might also like