Serial Interfaces, Part Deux
-I2C and SPI
December 4, 2002
Presented by Eugene Ho
Introduction
Serial Interfaces, part two
I2C and SPI
Serial communication protocols
Meant for short distances inside the box
Low complexity
Low cost
Low speed ( a few Mbps at the fastest )
To be discussed: Applications, protocols, tradeoffs, AVR
support
What is I2C?
Serial Interfaces, part two
Shorthand for an Inter-integrated circuit bus
Developed by Philips Semiconductor for TV sets in the 1980s
I2C devices include EEPROMs, thermal sensors, and real-time
clocks
Used as a control interface to signal processing devices that
have separate data interfaces, e.g. RF tuners, video decoders
and encoders, and audio processors.
I2C bus has three speeds:
Slow (under 100 Kbps)
Fast (400 Kbps)
High-speed (3.4 Mbps) I2C v.2.0
Limited to about 10 feet for moderate speeds
I2C Bus Configuration
Serial Interfaces, part two
2-wire serial bus Serial data (SDA) and Serial clock (SCL)
Half-duplex, synchronous, multi-master bus
No chip select or arbitration logic required
Lines pulled high via resistors, pulled down via open-drain drivers
(wired-AND)
I2C Protocol
Serial Interfaces, part two
1. Master sends start condition (S) and controls the clock signal
2. Master sends a unique 7-bit slave device address
3. Master sends read/write bit (R/W) 0 - slave receive, 1 - slave transmit
4. Receiver sends acknowledge bit (ACK)
5. Transmitter (slave or master) transmits 1 byte of data
I2C Protocol (cont.)
Serial Interfaces, part two
6. Receiver issues an ACK bit for the byte received
7. Repeat 5 and 6 if more bytes need to be transmitted.
8.a) For write transaction (master transmitting), master issues stop condition
(P) after last byte of data.
8.b) For read transaction (master receiving), master does not acknowledge
final byte, just issues stop condition (P) to tell the slave the transmission
is done
6
I2C Signals
Serial Interfaces, part two
Start high-to-low transition of the SDA line while SCL line is high
Stop low-to-high transition of the SDA line while SCL line is high
Ack receiver pulls SDA low while transmitter allows it to float high
Data transition takes place while SCL is slow, valid while SCL is high
I2C Features
Serial Interfaces, part two
Clock stretching when the slave (receiver) needs more
time to process a bit, it can pull SCL low. The master waits
until the slave has released SCL before sending the next bit.
General call broadcast addresses every device on the bus
10-bit extended addressing for new designs. 7-bit addresses
all exhausted
AVR Support for I2C
Serial Interfaces, part two
Atmel calls it Two-wire Serial Interface (or TWI)
Supported by all AVR 8-bit C except ATTiny and AT90
ATmega323 TWI mode when TWEN in TWCR is set:
PC0=SCL, PC1=SDA
TWBR sets bit rate
TWCR controls start, stop, ack generation, indicates M/S, T/R
TWDR contains byte transmitted/received
TWAR contains slave address
TWSR indicates status of TWI Bus (start condition
transmitted, ACK received, 26 total states)
I2C Tradeoffs
Serial Interfaces, part two
Advantages:
Good for communication with on-board devices that are accessed
occasionally.
Easy to link multiple devices because of addressing scheme
Cost and complexity do not scale up with the number of devices
Disadvantages:
The complexity of supporting software components can be higher
than that of competing schemes ( for example, SPI ).
10
What is SPI?
Serial Interfaces, part two
Shorthand for Serial Peripheral Interface
Defined by Motorola on the MC68HCxx line of microcontrollers
Generally faster than I2C, capable of several Mbps
Applications:
Like I2C, used in EEPROM, Flash, and real time clocks
Better suited for data streams, i.e. ADC converters
Full duplex capability, i.e. communication between a codec and
digital signal processor
11
SPI Bus Configuration
Serial Interfaces, part two
Synchronous serial data link operating at full duplex
Master/slave relationship
2 data signals:
MOSI master data output, slave data input
MISO master data input, slave data output
2 control signals:
SCLK clock
/SS slave select
(no addressing)
12
SPI vs. I2C
Serial Interfaces, part two
For point-to-point, SPI is simple and efficient
Less overhead than I2C due to lack of addressing, plus SPI is full duplex.
For multiple slaves, each slave needs separate slave select signal
More effort and more hardware than I2C
13
SPI Protocol
Serial Interfaces, part two
2 Parameters, Clock Polarity (CPOL) and Clock Phase (CPHA),
determine the active edge of the clock
CPOL
CPHA
Active edge
Rising
Falling
Falling
Rising
Master and slave must agree on parameter pair values in order to
communicate
14
SPI Protocol (cont.)
Serial Interfaces, part two
SPI interface defines only the communication lines and the clock
edge
There is no specified flow control! No acknowledgement mechanism
to confirm receipt of data
Hardware realization is usually done with a simple shift register
15
AVR Support for SPI
Serial Interfaces, part two
Supported by all AVR 8-bit C except ATTiny and some AT90s
ATmega323 - SPI mode when SPE bit in SPCR is set:
PB6=MISO, PB5=MOSI, PB7=SCK, PB4=/SS
SPCR sets bit rate, CPOL, CPHA, M/S
SPDR used for data transfer to and from SPI shift register
For multiple slaves, must employ bit-banging. Use software to
control serial communication at general-purpose I/O pins.
16
Summary
Serial Interfaces, part two
I2C and SPI provide good support for communication
with slow peripheral devices that are accessed
intermittently, mainly EEPROMs and real-time
clocks
I2C easily accommodates multiple devices on a single
bus.
SPI is faster, but gets complicated when there is more
than one slave involved.
17
References
Serial Interfaces, part two
I2C:
http://www-us2.semiconductors.philips.com/acrobat/various/
I2C_BUS_SPECIFICATION_1995.pdf
http://www.esacademy.com/faq/i2c/index.htm
http://www.embedded.com/story/OEG20020528S0057
SPI:
MC68HC11 manual
http://www.mct.net/faq/spi.html
http://links.epanorama.net/links/serialbus.html
http://www.embedded.com/story/OEG20020124S0116
18
