Scribd
Upload
52 views1 page

Structural Notes for Fabrication

The document contains design drawings and notes for three mechanical parts - a support plate, shaft holder, and wheels - produced using Autodesk educational software. The drawings are accompanied by three structural notes specifying that all dimensions are in millimeters unless otherwise stated, that the wheels will undergo transonic testing, and to verify all dimensions before fabrication begins.

Uploaded by

Hardik Batra
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
52 views1 page

Structural Notes for Fabrication

The document contains design drawings and notes for three mechanical parts - a support plate, shaft holder, and wheels - produced using Autodesk educational software. The drawings are accompanied by three structural notes specifying that all dimensions are in millimeters unless otherwise stated, that the wheels will undergo transonic testing, and to verify all dimensions before fabrication begins.

Uploaded by

Hardik Batra
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

PRODUCED BY AN AUTODESK EDUCATIONAL PRODUCT

SUPPORT PLATE
PRODUCED BY AN AUTODESK EDUCATIONAL PRODUCT

SHAFT HOLDER
PRODUCED BY AN AUTODESK EDUCATIONAL PRODUCT

STRUCTURAL NOTES 1. ALL DIMENSIONS ARE IN MILLIMETERS UNLESS OTHERWISE STATED 2. WHEELS ARE TO BE TRANSONICALLY TESTED 3. CHECK & VERIFY ALL DIMENSIONS BEFORE START OF FABRICTION

PRODUCED BY AN AUTODESK EDUCATIONAL PRODUCT

You might also like