BIOS Beep Codes

AMI BIOS Beeps

Error Message
Description
1 short DRAM refresh failure The programmable interrupt timer or programmable interrupt controller has probably failed
2 short Memory parity error A memory parity error has occurred in the first 64K of RAM. The RAM IC is probably bad
3 short Base 64K memory failure A memory failure has occurred in the first 64K of RAM. The RAM IC is probably bad
4 short System timer failure The system clock/timer IC has failed or there is a memory error in the first bank of memory
5 short Processor error The system CPU has failed
6 short Gate A20 failure The keyboard controller IC has failed, which is not allowing Gate A20 to switch the processor to
protected mode. Replace the keyboard controller
7 short Virtual mode processor exception error The CPU has generated an exception error because of a fault in the CPU or
motherboard circuitry
8 short Display memory read/write error The system video adapter is missing or defective
9 short ROM checksum error The contents of the system BIOS ROM does not match the expected checksum value. The
BIOS ROM is probably defective and should be replaced
10 short CMOS shutdown register read/write error The shutdown for the CMOS has failed
11 short Cache error The L2 cache is faulty
1 long, 2 short Failure in video system An error was encountered in the video BIOS ROM, or a horizontal retrace failure has
been encountered
1 long, 3 short Memory test failure A fault has been detected in memory above 64KB
1 long, 8 short Display test failure The video adapter is either missing or defective
2 short POST Failure One of the hardware testa have failed
1 long POST has passed all tests

COMPAQ CODES
Beeps
Error Message

Description

1 short
1 long, 1 short
2 short
1 long, 2 short
7 beeps (1 long,
1s, 1l, 1 short,
pause, 1 long, 1
short, 1 short

No error

System is booting properly

BIOS ROM checksum error

The contents of the BIOS ROM to not match the expected

contents. If possible, reload the BIOS from the PAQ

General error

Unknown

Video error

Check the video adapter and ensure it's seated properly. If

possible, replace the video adapter

AGP video

The AGP video card is faulty. Reseat the card or replace it

outright. This beep pertains to Compaq Deskpro systems

1 long
neverending
beep
1 short, 2 long

Memory error. Bad RAM. Replace and test

Bad RAM

Reseat RAM then retest; replace RAM if failure continues

BIOS Beep Codes

AMI BIOS Beeps
Error Message
Description
1 short DRAM refresh failure The programmable interrupt timer or programmable interrupt controller
has probably failed
2 short Memory parity error A memory parity error has occurred in the first 64K of RAM. The RAM IC
is probably bad
3 short Base 64K memory failure A memory failure has occurred in the first 64K of RAM. The RAM
IC is probably bad
4 short System timer failure The system clock/timer IC has failed or there is a memory error in the
first bank of memory
5 short Processor error The system CPU has failed
6 short Gate A20 failure The keyboard controller IC has failed, which is not allowing Gate A20 to
switch the processor to protected mode. Replace the keyboard controller
7 short Virtual mode processor exception error The CPU has generated an exception error because
of a fault in the CPU or motherboard circuitry
8 short Display memory read/write error The system video adapter is missing or defective
9 short ROM checksum error The contents of the system BIOS ROM does not match the expected
checksum value. The BIOS ROM is probably defective and should be replaced
10 short CMOS shutdown register read/write error The shutdown for the CMOS has failed
11 short Cache error The L2 cache is faulty
1 long, 2 short Failure in video system An error was encountered in the video BIOS ROM, or a
horizontal retrace failure has been encountered
1 long, 3 short Memory test failure A fault has been detected in memory above 64KB
1 long, 8 short Display test failure The video adapter is either missing or defective
2 short POST Failure One of the hardware testa have failed
1 long POST has passed all tests

AWARD BIOS
Beeps
Error Message
Description
1long, 2 short Video adapter error Either video adapter is bad or is not seated properly. Also, check
to ensure the monitor cable is connected properly.
Repeating (endless loop) Memory error Check for improperly seated or missing memory.
1long, 3short No video card or bad video RAM Reseat or replace the video card.
High frequency beeeps while running Overheated CPU Check the CPU fan for proper operation.
Check the case for proper air flow.
Repeating High/Low CPU Either the CPU is not seated properly or the CPU is damaged. May also
be due to excess heat. Check the CPU fan or BIOS settings for proper fan speed.

PHOENIX BIOS
Beeps
Error Message
Description
1-1-2 CPU test failure The CPU is faulty. Replace the CPU
Low 1-1-2 System board select failure The motherboard is having an undetermined fault. Replace
the motherboard
1-1-3 CMOS read/write error The real time clock/CMOS is faulty. Replace the CMOS if possible
Low 1-1-3 Extended CMOS RAM failure The extended portion of the CMOS RAM has failed.
Replace the CMOS if possible
1-1-4 BIOS ROM checksum error The BIOS ROM has failed. Replace the BIOS or upgrade if
possible
1-2-1 PIT failure The programmable interrupt timer has failed. Replace if possible
1-2-2 DMA failure The DMA controller has failed. Replace the IC if possible
1-2-3 DMA read/write failure The DMA controller has failed. Replace the IC if possible
1-3-1 RAM refresh failure The RAM refresh controller has failed
1-3-2 64KB RAM failure The test of the first 64KB RAM has failed to start
1-3-3 First 64KB RAM failure The first RAM IC has failed. Replace the IC if possible
1-3-4 First 64KB logic failure The first RAM control logic has failed
1-4-1 Address line failure The address line to the first 64KB RAM has failed
1-4-2 Parity RAM failure The first RAM IC has failed. Replace if possible
1-4-3 EISA fail-safe timer test Replace the motherboard
1-4-4 EISA NMI port 462 test Replace the motherboard
2-1-1 64KB RAM failure Bit 0; This data bit on the first RAM IC has failed. Replace the IC if possible
2-1-2 64KB RAM failure Bit 1; This data bit on the first RAM IC has failed. Replace the IC if possible
2-1-3 64KB RAM failure Bit 2; This data bit on the first RAM IC has failed. Replace the IC if possible
2-1-4 64KB RAM failure Bit 3; This data bit on the first RAM IC has failed. Replace the IC if possible
2-2-1 64KB RAM failure Bit 4; This data bit on the first RAM IC has failed. Replace the IC if possible
2-2-2 64KB RAM failure Bit 5; This data bit on the first RAM IC has failed. Replace the IC if possible
2-2-3 64KB RAM failure Bit 6; This data bit on the first RAM IC has failed. Replace the IC if possible
2-2-4 64KB RAM failure Bit 7; This data bit on the first RAM IC has failed. Replace the IC if possible
2-3-1 64KB RAM failure Bit 8; This data bit on the first RAM IC has failed. Replace the IC if possible
2-3-2 64KB RAM failure Bit 9; This data bit on the first RAM IC has failed. Replace the IC if possible
2-3-3 64KB RAM failure Bit 10; This data bit on the first RAM IC has failed. Replace the IC if possible
2-3-4 64KB RAM failure Bit 11; This data bit on the first RAM IC has failed. Replace the IC if possible
2-4-1 64KB RAM failure Bit 12; This data bit on the first RAM IC has failed. Replace the IC if possible
2-4-2 64KB RAM failure Bit 13; This data bit on the first RAM IC has failed. Replace the IC if possible
2-4-3 64KB RAM failure Bit 14; This data bit on the first RAM IC has failed. Replace the IC if possible
2-4-4 64KB RAM failure Bit 15; This data bit on the first RAM IC has failed. Replace the IC if possible
3-1-1 Slave DMA register failure The DMA controller has failed. Replace the controller if possible
3-1-2 Master DMA register failure The DMA controller had failed. Replace the controller if possible
3-1-3 Master interrupt mask register failure The interrupt controller IC has failed
3-1-4 Slave interrupt mask register failure The interrupt controller IC has failed
3-2-2 Interrupt vector error The BIOS was unable to load the interrupt vectors into memory. Replace
the motherboard

3-2-3 Reserved
3-2-4 Keyboard controller failure The keyboard controller has failed. Replace the IC if possible
3-3-1 CMOS RAM power bad Replace the CMOS battery or CMOS RAM if possible
3-3-2 CMOS configuration error The CMOS configuration has failed. Restore the configuration or
replace the battery if possible
3-3-3 Reserved
3-3-4 Video memory failure There is a problem with the video memory. Replace the video adapter if
possible
3-4-1 Video initialization failure There is a problem with the video adapter. Reseat the adapter or
replace the adapter if possible
4-2-1 Timer failure The system's timer IC has failed. Replace the IC if possible
4-2-2 Shutdown failure The CMOS has failed. Replace the CMOS IC if possible
4-2-3 Gate A20 failure The keyboard controller has failed. Replace the IC if possible
4-2-4 Unexpected interrupt in protected mode This is a CPU problem. Replace the CPU and retest
4-3-1 RAM test failure System RAM addressing circuitry is faulty. Replace the motherboard
4-3-3 Interval timer channel 2 failure The system timer IC has failed. Replace the IC if possible
4-3-4 Time of day clock failure The real time clock/CMOS has failed. Replace the CMOS if possible
4-4-1 Serial port failure A error has occurred in the serial port circuitry
4-4-2 Parallel port failure A error has occurred in the parallel port circuitry
4-4-3 Math coprocessor