25% found this document useful (4 votes)
1K views5 pages

Fortinet NSE4 Exam Questions and Answers

The document contains a practice exam for the Fortinet NSE4 certification. It includes 7 multiple choice questions covering topics like routing tables, VPN deployment types, DLP archiving, IPsec debugging output, HA cluster configuration, static routing, and FortiClient IPsec configuration.

Uploaded by

mcabrejosfe
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
25% found this document useful (4 votes)
1K views5 pages

Fortinet NSE4 Exam Questions and Answers

The document contains a practice exam for the Fortinet NSE4 certification. It includes 7 multiple choice questions covering topics like routing tables, VPN deployment types, DLP archiving, IPsec debugging output, HA cluster configuration, static routing, and FortiClient IPsec configuration.

Uploaded by

mcabrejosfe
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
  • Introduction
  • Topic 1, Volume A

NSE4

Fortinet - NSE4
Fortinet Network Security
Expert 4 Written Exam
(400)
Version: 7.0

http://Xcerts.com 1
NSE4

Topic 1, Volume A

QUESTION: 1
Review the output of the command get router info routing-table all shown in the Exhibit below;
then answer the question following it.

Which one of the following statements correctly describes this output?

A. The two routes to the 10.0.2.0/24 subnet are ECMP routes and traffic will be load balanced
based on the configured ECMP settings.
B. The route to the 10.0.2.0/24 subnet via interface Remote_1 is the active and the route via
Remote_2 is the backup.
C. OSPF does not support ECMP therefore only the first route to subnet 10.0.1.0/24 is used.
D. 172.16.2.1 is the preferred gateway for subnet 10.0.2.0/24.

Answer(s): A

QUESTION: 2
Identify the correct properties of a partial mesh VPN deployment:

A. VPN tunnels interconnect between every single location.


B. VPN tunnels are not configured between every single location.
C. Some locations are reached via a hub location.
D. There are no hub locations in a partial mesh.

Answer(s): B, C

QUESTION: 3
Data Leak Prevention archiving gives the ability to store files and message data onto a
FortiAnalyzer unit for which of the following types of network traffic? (Select all that apply.)

http://Xcerts.com 2
NSE4

A. SNMP
B. IPSec
C. SMTP
D. POP3
E. HTTP

Answer(s): C, D, E

QUESTION: 4
Review the IKE debug output for IPsec shown in the Exhibit below.

Which one of the following statements is correct regarding this output?

A. The output is a Phase 1 negotiation.


B. The output is a Phase 2 negotiation.
C. The output captures the Dead Peer Detection messages.
D. The output captures the Dead Gateway Detection packets.

Answer(s): C

QUESTION: 5
Two FortiGate devices fail to form an HA cluster, the device hostnames are STUDENT and
REMOTE. Exhibit A shows the command output of 'show system ha' for the STUDENT device.
Exhibit B shows the command output of 'show system ha' for the REMOTE device.

http://Xcerts.com 3
NSE4

Which one of the following is the most likely reason that the cluster fails to form?

A. Password
B. HA mode
C. Hearbeat
D. Override

http://Xcerts.com 4
NSE4

Answer(s): B

QUESTION: 6
Examine the Exhibit shown below; then answer the question following it.

The Vancouver FortiGate unit initially had the following information in its routing table:
S 172.20.0.0/16 [10/0] via 172.21.1.2, port2
C 172.21.0.0/16 is directly connected, port2
C 172.11.11.0/24 is directly connected, port1
Afterwards, the following static route was added:
config router static
edit 6
set dst 172.20.1.0 255.255.255.0
set pririoty 0
set device port1
set gateway 172.11.12.1
next
end
Since this change, the new static route is NOT showing up in the routing table. Given the
information provided, which of the following describes the cause of this problem?

A. The subnet 172.20.1.0/24 is overlapped with the subnet of one static route that is already in
the routing table (172.20.0.0/16), so, we need to enable allow-subnet-overlap first.
B. The 'gateway' IP address is NOT in the same subnet as the IP address of port1.
C. The priority is 0, which means that the route will remain inactive.
D. The static route configuration is missing the distance setting.

Answer(s): B

QUESTION: 7
Review the configuration for FortiClient IPsec shown in the Exhibit below.

http://Xcerts.com 5

NSE4 
 
1 
http://Xcerts.com 
 
 
 
 
 
 
 
Fortinet - NSE4 
Fortinet Network Security 
Expert 4 Written Exam 
(400) 
Version
NSE4 
 
2 
http://Xcerts.com 
 
Topic 1, Volume A 
 
 
QUESTION: 1 
Review the output of the command get router info routing-
NSE4 
 
3 
http://Xcerts.com 
 
 
A. SNMP 
B. IPSec 
C. SMTP 
D. POP3 
E. HTTP 
 
Answer(s): C, D, E 
 
 
QUESTION: 4 
Review
NSE4 
 
4 
http://Xcerts.com 
 
 
Which one of the following is the most likely reason that the cluster fails to form? 
 
A.
NSE4 
 
5 
http://Xcerts.com 
 
 
Answer(s): B 
 
 
QUESTION: 6 
Examine the Exhibit shown below; then answer the question fo

You might also like