We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
ECS MANUAL
Operation, Maintenance & Safety Manual
42.6.2 Preparation
1. If an alarm(Low salinity) occurs in freshwater zone, please operate according to the below
procedure.
2. Fill sea water(4~5% of total ballast volume) into Sea Water Holding Tank(APT or WBT) before
sailing the fresh water zone. The amount of sea water for mixing ballasting operation is subject to
be changed depending on the salinity of the area where the sea water is pumped in to sea water
holding tank.
Salinity Ratio between Fresh water and Marine water
of Marine Water
(Psu) Fresh water” (96) Marine Water (%)
30 95.00 5.00
31 95.16 4.84
32 95.31 469
33 95.45 455
34 95.59 441
347 95.70 430
35 95.71 429
36 95.83 4l7
37 95.95 4.05
1) Salinity of fresh water 0PSU
3. Open the valve installed before Sea Water Holding Tank (APT or WBT) to be use.
4. Check the status of related pumps and valves
5. Automatic Flow Control Valve functions throttling flow rate based on the measured Salinity
of mixed water(Target 1.5 PSU). Check "Measured value of CSU" on HMI screen,
A BES
OTN Ke OMA AOR Gece LUN S)
Caution
68
51-Q-19-09 TECHCROSS INC. Version.8200323, ECS MANUAL
Operation, Maintenance & Safety Manual
* CAUTION! Make sure that ll the valves on pipelines for operation mode are open,
Step 1: Click “OP MODE" on HMI MAIN screen.
Step 2: Click” "BALLAST" in "SELECT OPERATION MODE".
HM! operating requirements will be cisplayed in Required Signal
eeu
1. Close drain valve(s) connected to ECU.
2. Open inlet and outlet valves of the cooling water.
3. Open manual valve of TSU sampling line.
4, Start LT(Low Temperature) cooling pump for cooling water.
5. Operate the ballast pump.
/\ Alarm is activated, if ECS is not running within 5 minutes of ballast pump operation.
Caution
9-09 ECHCROSS INC ECS MANUAL
Operation, Maintenance & Safety Manual
Step 3: Ship's Valve and Pump Signal will be displayed in Ship's Signal.
Match Ship's Signal (ship's conditions) with Required Signal.
if these two requirements match, "RUN" button will be activated
42.63 Operation
Step 1: Select appropriate operation mode after checking related pumps and valves.
Check mode display to see if all the operation requirements are futfilled.
Click "RUN" button on HMI Screen to start ECS.
Leet
oy
etd
RRs acs
70
51-Q-19-09 IECHCROSS INC, Version.8200323, ECS MANUAL
Operation, Maintenance & Safety Manual
Step 3: Ensure that ECU value and TRO value are displayed in 5 minutes after starting ECS
Step 4: Click "STOP" and Ensure that message says, ‘Do you want to stop the ECS?"
x Ad 2)
i cies ed Reset
Step 5: Click "YES" button, Stop ballast pump after stopping ECS operation
9-09 ECHCROSS INC
