Scribd
Upload
120 views1 page

3 Check Harness and Connector (Ecm - Throttle Position Sensor)

This document provides diagnostic steps for checking the harness and connector between the ECM and throttle position sensor, as well as inspecting the throttle position sensor itself. It lists the standard resistance values that should be measured between terminals at the ECM connector and throttle position sensor connector in different throttle positions. Technicians are instructed to repair or replace the harness or connector if measurements are not within standards, or to replace the throttle position sensor if its measurements are not within standards.

Uploaded by

Clodoaldo Biassio
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
120 views1 page

3 Check Harness and Connector (Ecm - Throttle Position Sensor)

This document provides diagnostic steps for checking the harness and connector between the ECM and throttle position sensor, as well as inspecting the throttle position sensor itself. It lists the standard resistance values that should be measured between terminals at the ECM connector and throttle position sensor connector in different throttle positions. Technicians are instructed to repair or replace the harness or connector if measurements are not within standards, or to replace the throttle position sensor if its measurements are not within standards.

Uploaded by

Clodoaldo Biassio
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

05–91

DIAGNOSTICS – SFI SYSTEM (April, 2003)

3 CHECK HARNESS AND CONNECTOR(ECM – THROTTLE POSITION SENSOR)

(a) Disconnect the E3 ECM connector.


E3 (b) Measure the resistance between the terminals of the E3
ECM connector.
Standard:
Tester Connection Throttle Valve Specified Condition
VC (E3–18)
 2.5 to 5.9 kΩ
– E2 (E3–28)
VC
VTA(E3–21)
VTA(E3 21) Fully closed 0.2 to 5.7 kΩ
VTA E2 ECM Connector – E2 (E3–28) Fully open 2.0 to 10.2 kΩ
A65159
(c) Check the resistance between the terminals of the E3
ECM connector.
Standard (Check for short):
Tester Connection Specified Condition
VC (E3–18) – Body ground
10 kΩ or higher
VTA (E3–28) – Body ground
(d) Reconnect the ECM connector.
NG REPAIR OR REPLACE HARNESS OR
CONNECTOR

OK

REPLACE ECM (See page10–11 )

4 INSPECT THROTTLE POSITION SENSOR

Component Side: (a) Disconnect the T1 throttle position sensor connector.


Throttle Position Sensor (b) Measure the resistance between the terminals of the
T1 throttle position sensor.
Standard:
Tester Connection Throttle Valve Specified Condition
VC (T1–1) – E2 (T1–2)  2.5 to 5.9 kΩ
Fully closed 0.2 to 5.7 kΩ
VTA (T1–3)
(T1 3) – E2 (T1
(T1–2)
2)
Fully open 2.0 to 10.2 kΩ
VTA E2 VC
Front View A53154 (c) Reconnect the throttle position sensor connector.
NG REPLACE THROTTLE POSITION SENSOR

OK

2004 COROLLA (RM1037U)

Author: Date: 256

You might also like