Scribd
Upload
74 views1 page

J1

The document contains multiple choice questions about jigs and fixtures. It asks about the uses of different jig and fixture components like slip bush, liner, cam, conical locater and indexing fixtures. It also asks about the effects of using jigs and fixtures on factors like accuracy, labor cost and rate of production.

Uploaded by

sutha_me20098282
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
74 views1 page

J1

The document contains multiple choice questions about jigs and fixtures. It asks about the uses of different jig and fixture components like slip bush, liner, cam, conical locater and indexing fixtures. It also asks about the effects of using jigs and fixtures on factors like accuracy, labor cost and rate of production.

Uploaded by

sutha_me20098282
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd

10. Which of the following is not correct about fixture?

a) It is used to hold the work b) It is used to guide the cutting tool


c) It assures high accuracy of parts d) It is used to position the work the work
11. A diamond locating pin is used in jigs and fixtures because
a) diamond is very hard and wear resistant b) it occupies very little space
c) It has a long life d) It helps in assembly with tolerance on centre distance
12. Common feature between jig and fixture is that both are used for
a) locating the work piece b) holding the work piece
c) cutting the work piece d) testing and inspection of the work piece
13. Slip bush is used in jig where
a) the drill bit can slip on the work piece b) holes are too close
c) the bush is to be replaced every time d) a liner is used along with bush
14. Liner in a bush of a jig
a) offers lubrication b) strengthens the bush c) saves the bush from wear d) aligns the bush in a hole
15. A cam is used in a jig to
a) locate the work piece b) to clamp the work piece
c) move the work piece frequently d) lift a heavy work piece
16. A fixture is used to
a) save time b) easy machining c) fix odd shaped jobs d) none of above
17. A conical locater has the advantage of
a) easy location b) self-centering c) easy location and self‐centering d) offers good grid
18. With the use of Jigs and fixture
a) No effect in Labour cost b) Labour cost increases c) Labour cost decreases d) None of the
mentioned
19. With the use of Jigs and fixture rate of production will
a) Jigs are not used in any production process b) Decrease c) Remains same d) Increase
20.Which fixtures are used for machining parts which must have machined details evenly spaced?
a) Indexing fixtures b) Duplex fixtures c) Profile fixtures d) None of the above

You might also like