School of Electronics Engineering (SENSE)
ECE1002 Fundamentals of Electrical & Electronics Engineering
(Fall Semester 2023-24)
Assignment 2
Module 2 AC Circuit Analysis
Part I
1) Given the sinusoid 30sin(4πt-750), calculate its amplitude, phase, angular frequency,
period, and frequency.
2) A current source in a linear circuit has
I = 15cos(25πt+250) A
a) What is the amplitude of the current?
b) What is the angular frequency?
c) Calculate I at t = 2 ms
3) The maximum values of the alternating voltage and current are 400 V and 20 A respectively
in a circuit connected to 50 Hz supply and these quantities are sinusoidal. The instantaneous
value of the voltage and current are 283 V and 10 A respectively at t = 0 both increasing
positively. Write down the expression for voltage and current at time t.
4) Find the average and RMS values for the waveforms shown in Figure
(a)
(b)
(c)
(d)
(e)
(f)
(g)
(h)
(i)
(j)
(k)
(l)
(m)
(n)
Part II
1) A series RLC circuit containing a resistance of 10 Ω, inductance of 0.18 H and a capacitor
of 120 μF are connected in series across a 240 V, 50 Hz supply. Find
a) Impedance
b) Circuit current
c) Phase angle between voltage and current
d) Power factor
2) A parallel RLC circuit containing a resistance of 60 Ω, inductance of 80 mH and a capacitor
of 30 μF are connected in parallel across a 12 V, 60 Hz supply. Find
a) Impedance
b) Current flowing in each element.
3) Find the input impedance for the circuit shown in figure. Assume that the circuit operates
at ω = 50 rad/s.
4) Find the input impedance for the circuit shown in figure. Assume that the circuit operates
at ω = 10 rad/s.
5) Find input impedance for the circuit shown in figure
6) Find v(t) and i(t) for the circuit shown in figure
7) Find v(t) and i(t) for the circuit shown in figure
8) Determine V0(t) for the circuit shown in figure.
9) Determine V0(t) for the circuit shown in figure.
10) Determine the current that flows through an 8 Ω resistor connected to a voltage source
Vs = 110cos(377t) V
11) What is the instantaneous voltage across a 2 μF capacitor when the current through it is
i = 4sin(106t+250) A
12) A voltage v(t) = 100cos(60t+200) V is applied to a parallel combination of a 40 kΩ
resistor and a 50 μF capacitor. Find the steady state currents through the resistor and
capacitor.
13) A series RLC circuit containing a resistance of 80 Ω, inductance of 240 mH and a capacitor
of 5 mF are connected in series across a v(t) = 10cos2t
Find the current flowing through the circuit.
14) Find current i for the circuit shown in figure when
vs(t) = 50cos200t V
15) Find admittance for the circuit shown in figure
16) Find v(t) for the circuit shown in figure
17) Find i(t) for the circuit shown in figure
Part III
1) Calculate the instantaneous power and average power absorbed by the passive linear
network
v(t) = 330cos(10t+200) V and i(t) = 33sin(10t+600) A
2) A current I = 33∠300 A flows through an impedance Z = 40∠-220 Ω. Find the average
power delivered to the impedance.
3) For a load Vrms = 110∠850 V, Irms = 0.4∠150 A. Determine
a) Complex and apparent power
b) Real and reactive power
c) Power factor and load impedance
4) The voltage across a load and the current through it are given by
v(t) = 20+60cos(100t) V and i(t) = 1-0.5sin(100t) A
a) RMS values of the voltage and current
b) Average power dissipated in the load
5) For the following voltage and current phasors, calculate the complex power, apparent
power, real power, and reactive power. Specify whether the Power Factor (PF) is leading
or lagging.
6) For each of the following cases, find the complex power, average power and reactive
power
7) Determine the complex power for the following cases
8) For the circuit shown in figure, calculate
a) Power factor
b) Average power delivered by the source
c) Reactive power
d) Apparent power
e) Complex power
