Scribd
Upload
312 views8 pages

LCDM1 - Test Manual

This document provides instructions for testing the LCDM-1000 cash dispensing unit using the LCDMTP test program. It describes setting up the test program, navigating the menu to select the unit and perform dispensing and purge tests, checking the status of sensors, and testing additional machine functions on the TP page. The 8-page document is from 2002 and provides guidance on verifying the operation of the LCDM-1000 cash dispenser.

Uploaded by

darijavlad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
312 views8 pages

LCDM1 - Test Manual

This document provides instructions for testing the LCDM-1000 cash dispensing unit using the LCDMTP test program. It describes setting up the test program, navigating the menu to select the unit and perform dispensing and purge tests, checking the status of sensors, and testing additional machine functions on the TP page. The 8-page document is from 2002 and provides guidance on verifying the operation of the LCDM-1000 cash dispenser.

Uploaded by

darijavlad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

Test

Test Program
Program

Model : LCDM-1000
(Cash Dispensing Unit)

Total Page : 8 pages (including cover)

Date : 2002. 3
Version : V3.0(INT)

PULOON Technology Inc.


LCDM-1000

= Operating the LCDM-1000

I. SETUP

1) Start the test program “LCDMTP”


2) Maintain default value like below.
(If you need to choose another port, check the other
port number)
3) Press “OK” button

< Fig 1 : SETUP PAGE >

PULOON Technology Inc.


LCDM-1000

II. MENU

1) Choose LCDM-1000 or LCDM-2000

< Fig 2 : MENU PAGE >

PULOON Technology Inc.


LCDM-1000

2) DISPENSE

(1) Check UPPER


(2) Fill in the blank of “Upper Request Count” and “Repeat
Count” (Recommended Values are from 1~20 for the XXX

Request Count, and 1~999 for the Repeat Count)

(3) Press the button of “DISPENSE”

<Fig 3 : Ten bills are dispensed 1time from cassette>

PULOON Technology Inc.


LCDM-1000

(4) If Near-End occurs, V mark is checked at “Upper Empty”

<Fig 4 : Near-End occurs>

PULOON Technology Inc.


LCDM-1000

3) PURGE

If you want to clear the note in the path, press the button of “Purge”

<Fig 4 : Purge>

PULOON Technology Inc.


LCDM-1000

III. STATUS

1) Press “STATUS” button and all sensors are rechecked.


This shows system status for you.
2) If sensor error occurs, V mark is checked at each column
accordingly.

< Fig 5 : STATUS PAGE >

PULOON Technology Inc.


LCDM-1000

IV. TP

1) This page is about test program for checking each function and element
of the unit.
2) Motor Speed, Bill Length, Test Dispense, Diverting, RVDT
Value, ROM Version and Clutch Tests can be performed
and examined.

< Fig 6 : TP PAGE >

PULOON Technology Inc.

You might also like