lOMoAR cPSD| 12337774
lOMoAR cPSD| 12337774
AutoCAD Coordinate Systems
AutoCAD allows you to define the placement of a point using two different coordinate systems. The
Cartesian (rectangular) Coordinate System uses the “x” distance (left/right) and the “y” distance
(up/down). The Polar Coordinate System uses the distance between points (length or magnitude)
and the angle (direction or vector).
The system you use will depend upon the information you have. Rectangular coordinates are
typically used when you know your grid positions. Polar coordinates are typically used when you
know the exact angle between two points, along with the distance.
Five methods used to specify the locations of points:
I nteractive Method – Click points on the screen with the cursor. This method is the least
accurate unless you are using osnap or snap tools.
Absolute Cartesian Coordinate Method – x,y – Type the x and y coordinates on the
command line to locate a point relative to the origin (0,0).
Relative Cartesian Coordinate Method - @x,y - Type the x and y coordinates on the
command line to locate a point relative to the previous point.
Relative Polar Coordinate Method - @distance<angle - Type the distance and angle on the
command line to locate a point relative to the previous point.
Direct Distance Entry Method – Move the cursor in the correct direction and type the distance
on the command line (should be used with Ortho or Polar Tracking). This is the simplest method.
Surveyors Coordinates – @100'<n29d59'e - "n29d59'e" is the AutoCAD notation for "North
2959' East" and the distance precedes, making this method similar to Relative Polar Coordinates
***With AutoCAD versions 2008 and newer the state of “DYN” (Dynamic Input) determines whether Absolute
or Relative coordinates are in use. Coordinate entry may take place in the drawing area versus on the
command line.***
lOMoAR cPSD| 12337774
Example:
To Point B from Point A:
Absolute Cartesian coordinates: 0,0 (A) and 4,4 (B)
Relative Cartesian coordinates for Point B: 0,0 (A) and @4,4 (B)
Interactive method with Snap and Grid set to 1
To Point D from Point C:
Absolute Cartesian coordinates: -3,0 (C) and -3,4 (D)
Relative Cartesian coordinates for Point D: -3,0 (C) and @0,4 (D)
Interactive method with Snap and Grid set to 1
Relative Polar Coordinates for Point D: -3,0 (C) and @4<90 (D)
Direct Distance Entry for Point D: -3,0 (C) and 4 (D) with Ortho on and cursor above Point C
To Point F from Point E:
Absolute Cartesian coordinates: -3,-4 (E) and 3,-2 (F)
Relative Cartesian coordinates for Point F: -3,-4 (E) and @6,2 (F)
Interactive method with Snap and Grid set to 1
Why wouldn’t you use Polar Coordinates for line AB and line EF?
How would the relative coordinates be different if you draw the lines the other direction?
