Exit Exam mock Exam on introduction to Electrical Machine
1. The torque of a three- phase induction motor is ________ the supply voltage. (Create)
a) inversely proportional to the square of
b) directly proportional to
c) inversely proportional to
d) directly proportional to the square of
Ans. d.
2. pole induction motor, is supplied by a slightly unbalanced three-phase 50Hz source is
rotating at 1440rpm. the electrical frequency in Hz of the induced negative sequence
current in the rotor is (Apply)
a) 50
b) 72
c) 88
d) 98
Ans. d.
3. The rotor power output of a 3 phase induction motor is 15 KW and the corresponding slip
is 4%. The rotor copper loss will be (Apply)
a) 625 W
b) 500 W
c) 550 W
d) 600 W
Ans. a. 625W
4. A 2 KVA Transformer has iron loss of 150W and full Load copper loss of 250W. The
Maximum efficiency of the Transformer will occur when the Total loss is: (Apply)
a) 500W
b) 400W
c) 300W
d) 275W
Ans D
5. A 400/100V, 10KVA two –Winding transformer is reconnected as Auto- Transformer
Across a sutable voltage source . The Maximum rating of such an arrangement could be
(Analyze)
a) 50KVA
b) 15KVA
c) 12.5KVA
d) 8.75KVA
Ans C
6. A 10KVA 400V/200V , single phase Transformer with a percentage resistance of 3%
and Percentage Reactance of 6% is supplying a current of 50A to A resistive Load . The
Value of the Load Voltage is. (Evaluate)
a) 194V
b) 390V
c) 192V
d) 196V
Ans A
7. A three phase induction motor is running at 2% slip. If the input rotor is 1000W, then
mechanical power developed by the Motor. (Evaluate)
a) 20W
b) 500W
c) 980W
d) 200W
Ans c
8. The cause of hunting in synchronous motor are: (Remember)
a) Sudden change occur in Load
b) Sudden change occur in the field current
c) Cyclic variation in load torque
d) All of the above
Ans .D
9. The V-curve of a synchronous motor shows the relationship between
(Analyze)
a) Excitation current and back e.m.f
b) Field current and power factor
c) D.C field current and armature current
d) Armature current and supply voltage
Ans (c)
10. The two methods of synchronizing an alternator are? (understand)
a) Loading effect and phase sequence
b) Lamp method and synchroscope method
c) Two bright and one dark lamp method
d) Hysteresis loss and friction loss method
Ans b
