ADOR POWERTRON LIMITED
Technical Specification of DC Rectifier Document Number 5000207
Module for Hydrogen Electrolyser Prepared By SSV Date 20.09.22
Approved By PVG Date 20.09.22
Rating : 30kW
Introduction:
DC module is developed specially by Ador Powertron limited for Hydrogen electrolysis purpose. With
three-phase non neutral conductor AC input, it has the advantages of high efficiency, high power
density and low harmonic.
Appearance:
Technical Parameter:
Category Name Parameter
Input system Three phases + PE
Voltage range 260 Vac ~ 530 Vac
Rated voltage 415 Vac ± 15%
Maximum current 58A
Grid frequency 45 Hz~ 65 Hz
Rated frequency 50Hz/60Hz
AC input
Standby power consumption < 12W@380Vac，
< 14W@480Vac with normal standby mode
Three-phase equilibrium The difference between the maximum and
minimum voltage of neutral conductor for
three-phase input ≤ 10V
Voltage range 150 Vdc ~ 1000Vdc (settable)
Current range 0 ~ 100A (current limiting point is settable)
Rated Power 30kW
DC output Steady voltage precision <±0.5 %
Steady current precision ≤±1% (rated range of 20% ~ 100% for
output load)
Load regulation ≤±0.5%
Line regulation ≤±0.1% (testing range is 320V ~ 530V)
Start-up overshoot ≤±3%
Peak-to-peak value noise ≤1% (200~1000V, 0~20MHz)
00 Original document SSV 20.09.22 PVG 20.09.22
Revision No Description Prepared By Date Approved By Date
Page 3 of 3
ADOR POWERTRON LIMITED
Technical Specification of DC Rectifier Document Number 5000207
Module for Hydrogen Electrolyser Prepared By SSV Date 20.09.22
Approved By PVG Date 20.09.22
Rating : 30kW
Category Name Parameter
≥0.95 Full-load output power of
Power factor Power factor @25%~50%
THD ≥0.98 Full-load output power of
@50%~100%
≥0.99 Full-load output power, input nominal
voltage and frequency of @100%
THD ≤5% Full-load output power of
@50%~100%
Efficiency At nominal input and rated output ≥95.2％ at Vout = 1000V-30A
At nominal input voltage and load from ≥95.0％ at Vout = 350 to 500Vdc
50%~100% ≥95.0％ at Vout = 680 to 1000Vdc.
Communication Communication with Controller/PLC CAN Bus Interface.
Controller/PLC to EMS server Profinet/Profibus
EMC Emission Class B (RE is Class A for Output Port
according to standard)
According to IEC 61000-6-3
Immunity According to IEC 61000-6-1
Certification CE/TUV IEC61851-1, UL2202
Environmental Operation temperature -40°C ~ +75°C, derating is required when
conditions the temperature is above 55°C.
Storage temperature -40°C ~ +70°C
Relative humidity ≤95%RH, without condensation
Cooling mode Forced air cooling
Altitude 2,000 m a.s.l., derating is required when
the altitude is above 2,000 m a.s.l.
Atmospheric pressure 79 kPa ~ 106 kPa
Instant impulse current upon startup <60A
Current sharing In case of load of 10%~100%, the module
current sharing error ≤ rated output current
of ±5 %.
Noise ≤60dB (1m away，ambient temperature is
25℃, under rated input voltage and output
is1000V-30A
Startup duration (select the startup Normal start-up mode: the time delay from
mode through the monitoring module) AC power-on to module output is ≤ 8s.
Output delayed startup: The startup
duration can be set through the monitoring
Other module, with default
output start-up duration of 3~8s.
Earthing resistance Earthing resistance ≤ 0.1Ω, bearable
current ≥ 25A
Lighting protection 5kA
00 Original document SSV 20.09.22 PVG 20.09.22
Revision No Description Prepared By Date Approved By Date
Page 3 of 3
ADOR POWERTRON LIMITED
Technical Specification of DC Rectifier Document Number 5000207
Module for Hydrogen Electrolyser Prepared By SSV Date 20.09.22
Approved By PVG Date 20.09.22
Rating : 30kW
Category Name Parameter
Hot Plug Yes
Insulation resistance The insulation resistance of DC part and
AC part to housing and the AC part to the
DC part shall be
≥ 10MΩ.
Insulation strength for 1 min duration The AC input terminal to the CAN
side 4242V DC voltage,
The AC input terminal to the
enclosure 2121V DC Voltage
The AC input terminal to the DC output
terminal 2121V DC voltage,
The DC output terminal to the
enclosure 2121V DC voltage
The DC output terminal to the CAN
side 4242V DC voltage
The CAN to the enclosure 707V DC voltage
There is no breakdown and flashover, and
the steady leakage current is less than
1mA.
ROHS R6
Mechanical Size 110Mm (H) ×385mm (W) ×395mm (D)
parameters Weight ≤22.5kg
00 Original document SSV 20.09.22 PVG 20.09.22
Revision No Description Prepared By Date Approved By Date
Page 3 of 3
