BCA101 - Digital Electronics
Multiple Choice Questions
1. i) The maximum positive number that can be represented in 1’s complement representation is
a) 2 n-1 – 1 c) – (2 n-1 – 1)
b) 1 – 2 n-1 d) 2 n-1
ii) The value of F is
om
a) 0 c) A
b) 1
t.c d) A’
iii) A decoder with enable input can be used as
bu
a) Encoder c) NAND
b) Parity Generator d) Demultiplexer
iV) Which of the following is self-complementing code?
yw
a) Gray d) Parity code
b) Excess-3 e) Hamming code
m
c) BCD
v) How many Flip-flops are required to design MOD-1024 counter?
a) 1024 c) 10
b) 102 d) 1
vi) The decimal equivalent of the binary number ( 101111.1101 ) 2 is
a) ( 46.8125 ) 10 c) ( 47.8155 ) 10
b) ( 47.8125 ) 10 d) ( 47.8145 ) 10
vii) Which family has the better noise margin?
a) ECL c) DTL
b) MOS d) TTL
viii) J-K flip – flop has
a) one stable state c) no stable state
b) two stable state d) none of these
ix) Master-slave configuration is used in flip-flops to
a) increase its clicking rate
b) reduce power dissipation
c) eliminate race around condition
d) improve its reliability
x) The equation √213 = 13 is valid for which one of the number syatems with base?
om
a) Base 8 c) Base 6
b) Base 6 d) Base 4
xi) Simplified form of Boolean expression
t.c
F (A, B, C) = ABC + A’BC + AB’C + ABC’ is
a) AB + BC + CA c) AB + B + CA
bu
b) A + BC + CA d) ABC + A + B + C
xii) PROMs are used primarily for
yw
a) data storage
b) temporary program and data storage
c) they are inexpensive
m
d) permanent program & data storage
Short Answer Type Questions
2. Implement a full adder circuit using decoder.
3. Design a combinational circuit using an 8 х 4 ROM that accepts a 3-bit number & generates an
output binary number equal to the square of input no.
4. Simplify the following expression using K-map
Y = π (0, 1, 4, 5, 6, 8, 9, 12, 13, 14)
5. Check whether the Even parity Hamming code for 4-bit data, ( 1001011 )2 is correct or not. If
not, correct the code.
6. Explain race around condition of J-K flip-flop. Show how this condition can be avoided.
7. Perform the arithmetic operation:
(-22)decimal + (13)decimal + (-15)decimal
Using 2’s complement binary form.
Long Answer Type Questions
8. a) Design an asynchronous 4-bit up-down counter and it will count up when a signal line M = 0
and count down when a signal line M = 1.
b) Design a sequential circuit that implements the following state diagram. Use all D-type FF for
the design.
om
t.c
bu
yw
9. a) Write down the excitation table of JK and D flip-flops. Derive the excitation equations for
theses two flip-flops.
m
b) Design a clocked R-S flip-flop using NAND gates. Explain its principle of operation.
10. a) Simplify the following function using K-map.
i) F = π m (0, 1, 3, 8, 10, 15) . π d (11, 13, 14)
ii) F = 𝛴𝛴 m (0, 4, 7, 9, 13, 15) + 𝛴𝛴 d (10, 14)
b) What is ROM and RAM? What is the basic difference between EPROM and EEROM?
11. a) Draw a neat diagram for a R-2R ladder type DAC. What is linearity error and offset error in a
DAC?
c) Find the conversion time of a successive approximation A/D converter which uses a 2 MHz
clock and a 5-bit binary ladder containing 8V reference. What is the conversion rate?
12. Write short notes on any three of the following:
a) CMOS Logic
b) Tri-state gates in TTL family
c) A/D convertor
d) Data lock-out in a counter
e) EPROM
om
t.c
bu
yw
m
