LORDS INSTITUTE OF ENGINEERING & TECHNOLOGY
(UGC Autonomous)
Approved by AICTE | Affiliated to Osmania University | Estd.2003.
Department of Civil Engineering
A.Y: 2024-2025
[Link] SEMESTER
Name of the Subject: Design of Steel Structures
ASSIGNMENT – 3
Date of Issue 16-12-2024 Last Date of Submission: 27-12-24
[Link]
Bloom’s
Course
Q. No. Question Marks Taxonomy
Outcome
Level
1 Design a built up column of effective length 5m to 02 CO4 BTL4
carry an axial load of 1000 KN using lacing.
Design the connections using fillet welds. Grade of
steel is E250.
2 Design a gusseted base for a beam column SC250 to 02 CO4 BTL4
transfer a factored axial compression of 800 KN and a
factored bending moment of 80 KN-m. Grade of steel
is E250 and grade of concrete pedestal is M30.
3 Design a splice for a beam-column using high 02 CO4 BTL3
strength bolts of property class 8.8
The factored axial load = 750 KN
The factored bending moment = 150 KN-m
Factored Shear Force = 75 KN
Section of column is SC250
Assume that the ends of column are milled and
connections are bearing type.
4 What are the various loads that act on a truss. Explain 02 CO5 BTL2
briefly with relevant formulae
5 Design an I-section purlin for a trussed roof from 02 CO5 BTL4
the following data using sag bars
Span of roof = 12m
Spacing of trusses = 5m
Spacing of purlins along slope of roof truss = 2m
Slope of roof truss = 1V to 2H
Wind load on roof surface normal to roof = 1000
N/m2
Vertical load from roof sheets = 200 N/m2
Bloom's Taxonomy Levels (BTL)
BTL1 –Remember BTL2 Understand BTL3 –Apply
BTL4-Analyze BTL5 –Evaluate BTL6 –Create
ote:
1. Answer all Questions.
2. Answer to the assignment questions are to be written on A4 size papers only.
3. Each page of the assignment paper should contain full roll number of the student.
4. The hard copy of the assignment is to be submitted on or before 27/12/2024.
Faculty HOD
