QUICK GUIDE Power OFF

In “Ground Mode” and if “ECO Mode” is enabled, The PROTRACK II™

Power ON
The PROTRACK II™ has been turned Ground Mode
automatically switches off 14 hours after the last jump or 14 hours after off prior to shipping from our factory. To save battery power, after power up and shortly after landing the PROTRACK II™ enters “Ground
pressing any button, whichever comes last. Mode”. In this mode, 60 seconds after last button pressed, the display will switch off. However, the
To turn the power on, press and hold PROTRACK II™ is still ready for jumping.
The PROTRACK II™ can also be manually powered off from the Setup any key until the unit beeps, then
Window, to further extend the battery life when not in use. release the key. Flight Mode
Shortly after takeoff the PROTRACK II™ switches to “Flight Mode” and displays the “Flight Mode”
Note: When switched off, the PROTRACK II™ can not be used for jumping. window. At the lowest preset “Climb to altitude” (factory preset to 1,000 feet), the PROTRACK II™
Customer settings are not lost when the unit is switched off. sounds a sequence of beeps. These beeps have two functions:

1. The beeps indicate that the PROTRACK II™ has calibrated itself to the local ground elevation and
is ready to jump.

2. The number of beeps indicate the altitude at which the high speed warning is set; for example: If
Device Info set to 4,500 feet, the sequence will be beep-beep-beep-beep (pause) beep. The number of rapid-
When starting up, the PROTRACK II™ sequence beeps indicate the highest warning altitude in thousands of feet. The beep after the pause
Battery capacity in mVolt
runs a self-test and beeps three times (if any) signifies a 500-foot increment.
while flashing the screen twice. Barometric pressure in mBar (hPa)
Should the battery voltage of the PROTRACK II™ be low, the beep sequence is followed by 5 short
Temperature (Celcius or Fahrenheit) beeps. This indicates that the battery should be replaced.
It then displays device info.
Free logbook storage in percent
Firmware version

Climb to Altitude High Speed Warnings Low Speed Firmware version

Flight Mode Warnings (CL) (HI) Decent Warnings (LO) Logbook Logbook Total Clock Setup and serial number
WINDOWS
MAIN

REV. 02, OCTOBER 2022

Press and
MM-DD
hold
HH-MM
> 5 seconds

To avoid any unintentional changes, all settings

are “locked” behind an ACCESS procedure.
ACCESS is required to unlock and change any 4 “climb to warning” banks. 4 “high speed warning” banks. 4 “low speed warning” banks. Displays all stored Displays any stored Date and time in Setup options
Displays altitude
settings. Each bank supports up to 4 Each bank supports up to 4 Each bank supports up to 4 jumps logbook totals device. Displays in
and clock while in
flight mode warning altitudes warning altitudes warning altitudes either 12 or 24 Hrs

ACCESS
ACCESS ACCESS ACCESS ACCESS ACCESS ACCESS ACCESS ACCESS

Press and release the mode

1 button – the lock icon turns off
Altitude Offset Climb to altitude High speed Low speed Logbook options Logbook total Clock options Setup options
warning options warning options warning options options ( is factory defaults)
2 When the lock icon reappears,
immediately press and hold the ■ Change altitude ■ Select bank ■ Select bank ■ Select bank Logbook screen 1 ■ Set total number of ■ Set year ■ Power OFF
mode button – the lock icon ■ Set or disable ■ Set or disable ■ Set or disable ■ Jump number jumps ■ Set month ■ AUT / ECO
turns off again warnings warnings warnings ■ Exit altitude ■ Set total hours ■ Set day ■ Beep on / off
■ Set volume ■ Set volume ■ Set volume ■ Deployment altitude ■ Set total minutes ■ Set 12/24 hr clock ■ Dive type*
3 When the lock icon reappears,
release the mode button .
■ Set pitch
■ Hear selected
■ Set pitch
■ Hear selected
■ Set pitch
■ Hear selected
■ Freefall time
■ Speeds (scrolls
■ Set total seconds
■ Delete complete
■
■
Set hour
Set minutes
■
■
TAS / SAS
Feet / Meters
- The PROTRACK II™ is now in warnings, volume warnings, volume warnings, volume through AVG, MAX, logbook ■ MPH / KM/H
ACCESS. and pitch and pitch and pitch 1st, and 2nd half) ■ Celcius / Fahrenheit
Caution ■ Reset to factory
Note: The PROTRACK II™ exits ACCESS and returns Once the logbook is default
to the Main Window if no button has been pressed Logbook screen 2 deleted there is no
within 30 seconds. ALL functions (except Power ON) ■ Jump number way to restore the
can be performed ONLY when the PROTRACK II™ is in ■ Year for the jump information. *Dive types:
ACCESS mode. ■ Month and date for ■ ----- (Normal)
the jump Press to view ■ 3-SEC
In main window In main window In main window ■ Hours and minutes “Remaining logbook In 3-SEC mode the descent rate parameters are more sensitive, allowing
toggle left perform ACCESS toggle right for the jump storage” window detection of short freefall (>3 sec. freefall) for logbook exit generation.
■ Dive type See manual for important notes.
■ SLO (Slow)
In SLO mode the deployment parameters are more sensitive. Supports slow
Logbook screen 3 falling types of dives, like normal wing suit dives etc.
■ Jump number ■ S-SLO (Super slow)
In sub-menu In sub-menu In sub-menu ■ Altitude at time
increase value set/next menu decrease value
In S-SLO mode the exit and deployment parameters are more sensitive. This
■ Freefall and canopy mode is for very slow wing suit dives, fast canopy descents, extreme relative
status work (XWR) etc. All “high speed warnings” are enabled regardless of the
■ Time after exit in vertical air speed at the preset altitude. See manual for important notes.
seconds
WARNING ■ Speed at time
This Road Map does not replace the
PROTRACK II™ Manual nor releases the
user from the obligation to comply with the
Press to “Delete
contents of the PROTRACK II™ Manual. last jump” window

Press to view
“Remaining logbook
storage” window

USB Mode
If a USB host device is connected to the PROTACK II™ USB port, the
PROTRACK II™ will act as a USB slave and show “USB” on the LCD display.

Visit [Link] for applications that support PROTRACK II™.

Error Mode
When the PROTRACK II™ detects a fault, an error (“ERR”) sign, number, and
code is displayed. At the same time the unit beeps once every minute.

All faults indicate that the PROTRACK II™ is defective. Error number
Remedy: Replace batteries or perform reset.
Error code
If the unit does not function correctly even after replacing the batteries and
pressing reset, please contact your local dealer or LB Altimeters.
Visit [Link] Instructional videos
for manual and YouTube
and support channel
 ROAD MAP Climb to Altitude High Speed Low Speed

WINDOWS
Flight Mode Warnings Warnings Decent Warnings Logbook Logbook Total Clock Setup

MAIN
MM-DD

HH-MM

ACCESS ACCESS ACCESS ACCESS ACCESS ACCESS ACCESS ACCESS

Altitude Offset Bank Bank Bank Logbook: Main information Set total jumps Year Switch off
To switch off,
set flashing
value to 10

Warning 1 Warning 1 Warning 1 Logbook: Date, time, and dive type Set total hours Month ECO/AUTO

REV. 02, OCTOBER 2022

Warning 2 Warning 2 Warning 2 Logbook: Playback, Jump profile Set total minutes Day Turn beep on/off
To avoid any unintentional changes, all settings
are “locked” behind an ACCESS procedure. Press
ACCESS is required to unlock and change any to move
settings. forward in
time.
Press
ACCESS to move
back in time

Press and release the mode

1 button – the lock icon turns off
Warning 3 Warning 3 Warning 3 Delete jump
To delete jump,
Set total seconds 24/12 hour clock Dive type

set flashing
2 When the lock icon reappears,
immediately press and hold the value to 10
mode button – the lock icon
turns off again

3 When the lock icon reappears,

release the mode button .
- The PROTRACK II™ is now in
ACCESS.
Warning 4 Warning 4 Warning 4 Remaining logbook storage Delete logbook Hours TAS/SAS
Note: The PROTRACK II™ exits ACCESS and returns
to the Main Window if no button has been pressed
Free logbook To delete
within 30 seconds. ALL functions (except Power ON) storage in logbook, set
can be performed ONLY when the PROTRACK II™ is in percent flashing value
ACCESS mode. to 123

In main window In main window In main window

toggle left perform ACCESS toggle right

Volume Volume Guide on/off Remaining logbook storage Minutes Feet/Meter

Free logbook
In sub-menu In sub-menu In sub-menu storage in
increase value set/next menu decrease value percent

WARNING
This Road Map does not replace the
PROTRACK II™ Manual nor releases the
user from the obligation to comply with the
contents of the PROTRACK II™ Manual.

Pitch Pitch Volume MPH/KMH

Test Test Pitch Celsius/Fahrenheit

Test Reset to factory default

To reset to
facory default,
set flashing
value to 123

Visit [Link] Instructional videos

for manual and YouTube
and support channel