Center Pivot Components
Center pivots have evolved into complex machines that do more than just move in a circle and pump
water onto the ground. But even with all the complexities, a modern-day pivot can be broken down into
a handful of main components that make up the core framework. These major components include the
pivot point, control panel, spans, drive units, and tower boxes.
1. Pivot Point
The pivot point anchors the machine to a permanent location in the field. Not only is it an anchor, but it
also houses a system of subcomponents that contribute to the overall functionality of the pivot. These
important subcomponents are the pivot legs, riser pipe, pivot swivel, control panel, J-pipe, and collector
rings.
A) Pivot Legs - The pivot legs hold up the pivot point and give the machine its structure. The four pivot
legs are typically bolted to a concrete pivot pad, providing support.
B) Riser Pipe - The riser pipe is connected to the first span through the pivot swivel. The purpose of the
riser pipe is to supply water to the rest of the pivot.
C) Pivot Swivel - The pivot swivel is an elbow-shaped fitting that connects the riser pipe to the first span.
D) Control Panel - The control panel is mounted and accessed at the pivot point. The control panel gives
the machine commands to start, stop, move in reverse, pump water, and many other functions. More
on this component later.
E) J-Pipe - The J-pipe houses the power and control circuit wires. These wires move through the J-pipe to
the collector ring assembly.
F) Collector Ring - The collector ring assembly is made up of stationary brass rings with contact brushes
that rotate around them. This assembly makes it possible for a continuous flow of electricity to run
through the machine as it rotates around the pivot point.
2. Control Panel
The control panel is the brains of the operation. It allows the operator to control the entire machine by
sending commands to tower boxes mounted on each drive unit. The control panel controls the stopping,
starting, forward and reverse movements of the pivot, water usage, and much more.
3. Spans
Spans are the backbone of the whole center pivot structure. Spans consist of pipes that transfer water
to the field via the pivot’s sprinkler package. The span pipes are supported by trussing and the drive
units.
4. Drive Units
The drive units and the supporting structure are also known as towers. They provide clearance above
the crop for the spans and control the movement of the machine. Each drive unit consists of a drive
motor, gearboxes, wheels, and an electrical control box known as a tower box.
5. Tower Boxes
Each drive unit has a tower box that uses various components to control pivot movement and
alignment. Span cables carry 120 and 480 volts of alternating current (VAC) to each tower box. Tower
boxes then send 480VAC to the drive motors when signaled to move by the 120VAC control circuit.
