熊仔科技出品
iDraw Assembly User Guide
[Link]
x2
Assemble these two parts
This step uses these parts
Stepper motor Pulley Toolkit
Acr ylic Screw M3x8 Short aluminum Screw M6x8
package
assembly Pulley
Lock Headless screw One of the headless screws is needed
Crush the motor shaft of the D-plane
(This ensures that the pulley is work well
, nor loose)
Note the correct way Top view
Screw M6x8
Screw M3x8
Note the correct way
Congratulation！Finish this part
Assemble this parts(Cable ties isn’t show)
This step uses these parts
Acr ylic-Down
Bearings LM8UU LM6UU Cable ties
Acr ylic-UP
First assembly of acr ylic and large linear bearings LM8UU
The tie passes through the acr ylic plate Force the tie to tighten! Must be tightened!
The remaining few linear bearings operate the same Cut off the excess tie
assembly of acr ylic and small linear bearings LM8UU
The same operation, force the tie to tighten
Done!please check it!
This step uses these parts
Brass female-female standoff Screws M3X6 Screws M4X45
Standoff Plastic Flanged Bearing Nut M4
Brass female-female standoff
Screws M3X8
Screws M4X45
Standoff Plastic
Flanged Bearing
Standoff Plastic
assemly
Nut M4
Screws M3X8
This step uses these parts
Acr ylic Screws M3X8 T-Nut M3
Screws M3X8
T-Nut M3
Screws M4X10
Screws M4X10
This step uses these parts
3dprinting plastic parts Screws M3X8 Screws M4X10
Standoff Plastic Flanged Bearing Acr ylic
Screws M3X8
Screws M3X8
If you do not know how to assemble,you can watch the video to fit the belt
(video03 from 05:30)
belt
This step uses these parts
Brass male-female standoff Screws M3X8
T-Nut M3 Acr ylic
Lock T-nuts
The other side is the same operation
Screws M3X6
Screws M3X8
You need to watch the video, and
adjust the steering gear rocker arm
(video03 form 39:00)
舵机 打印件 螺丝M3x8
Screws M3X6
Screws M3X8
Screws M3X6
You can change the angle of the pen
