Scribd
Upload
2K views1 page

Manual Calibracion Balanza SW-1

The document provides instructions for span calibrating the SW-Series scale. It details removing the sealing bolt and calibration plate to access the calibration button. It then instructs to press and hold the calibration button while turning the scale on to enter calibration mode. The user is directed to load the proper weight for the scale's capacity and press the on/off button to complete calibration. Steps are outlined to repeat the calibration process if the scale is not accurate after the initial calibration.

Uploaded by

Amber Atkins
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
Download as pdf or txt
2K views1 page

Manual Calibracion Balanza SW-1

The document provides instructions for span calibrating the SW-Series scale. It details removing the sealing bolt and calibration plate to access the calibration button. It then instructs to press and hold the calibration button while turning the scale on to enter calibration mode. The user is directed to load the proper weight for the scale's capacity and press the on/off button to complete calibration. Steps are outlined to repeat the calibration process if the scale is not accurate after the initial calibration.

Uploaded by

Amber Atkins
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
Download as pdf or txt
Download as pdf or txt
You are on page 1/ 1

12/30/99

CAS (USA) Corporation y 99 Murray Hill Parkway y East Rutherford, NJ 07073

SW-Series

SPAN CALIBRATION FOR SW-Series


1. Please make sure that all of your programming options are set properly before you span calibrate the scale. If you change any options later, you may have to redo this entire procedure. To set the programming options correctly, follow the steps of the Programming For SW-Series sheet. Make sure scale is OFF. Remove the platter assembly (metal and plastic platform.) On the right hand side you will find a hole and a screw at the bottom. This is the SEALING BOLT. Please remove the SEALING BOLT and then turn the scale upside-down to find the CALIBRATION BOLT and PLATE located on the right side of the bottom of the scale (if keyboard is facing you and you tilt the scale upwards by the front.) Remove the CALIBRATION BOLT and the silver PLATE. Under the PLATE you will see the calibration button: SW#1. Press and hold down SW#1 then press the ON/OFF key.

2. 3.

4.

5. 6.

CAL . Release SW#1 and place the platter assembly (metal and plastic The display will show platform) back onto the scale. ULOAd . Make sure that there is nothing Press the ON/OFF key 5 times until the display reads on or obstructing the platter, and that the platter is properly set on the platform cushions.
Press the ON/OFF key. The display will show

7.

8. 9.

StAbL , then it will show


20 lb / 10 kg 50 lb / 25 kg

LOAd .

Place the proper weight on the platter and then press the ON/OFF key (see capacity chart.) 5 lb or 2 kg 10 lb / 5 kg

10.
11.

The displays will show

StAbL , then show

End , and then display will be blank.

Remove the weight from the platter and then press the ZERO key. Test the accuracy of the scale. A) B) If scale is NOT 100% accurate, unplug scale and repeat steps 2 to 11. If scale IS 100% accurate, then you are done.

12.

You might also like