Scribd
Upload
25 views2 pages

Design Desc Compound

Device A has two alternative designs: 1. Uses preset Arduino chip to command rotation of rear wheels to turn to a preset angle and launch a load towards platform B using a spring launcher. 2. Uses preset Arduino chip to control left and right rotation of a wheel to move to a bucket, which triggers a switch to stop motion and lift the load into the bucket using a motor and string. Device B also has two alternatives: 1. Uses a triggered coil spring to rotate a gear system and rope climber to raise a platform once a transfer load sits in a hole. 2. Uses a triggered plate to release a platform from a loop once a transfer load falls into a crater and presses

Uploaded by

Vincent Wong
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
Download as docx, pdf, or txt
25 views2 pages

Design Desc Compound

Device A has two alternative designs: 1. Uses preset Arduino chip to command rotation of rear wheels to turn to a preset angle and launch a load towards platform B using a spring launcher. 2. Uses preset Arduino chip to control left and right rotation of a wheel to move to a bucket, which triggers a switch to stop motion and lift the load into the bucket using a motor and string. Device B also has two alternatives: 1. Uses a triggered coil spring to rotate a gear system and rope climber to raise a platform once a transfer load sits in a hole. 2. Uses a triggered plate to release a platform from a loop once a transfer load falls into a crater and presses

Uploaded by

Vincent Wong
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
Download as docx, pdf, or txt
Download as docx, pdf, or txt
You are on page 1/ 2

Alternative Designs for Device A

Device A Alternative 1
Functioning box batteries, preset Arduino chip, motor,
mouse printed circuit board.
In order to turn to certain angle, preset Arduino chip will
command to rotate one of the rear wheels and stop the
other rear wheel. The front wheel will rotate together with
their connected rear wheel.
After moving to the pre-set location, the spring launcher on
the arm throws the load towards the platform B.
Device A Alternative 2
Functioning Box consists of batteries, preset Arduino chip,
motor, mouse printed circuit board.
In order to control the direction, the wheel is rotated left
and right command from the preset Arduino chip. The
distance travelled is observed by the mouse sensor.
Once it reaches the bucket, it will hit the bucket. This will
trigger the switch and stop the motion, follow by lifting the
load up by motor through a string and transfer the load into
the bucket through the bridge.
Alternative Designs for Device B




Device B Alternative 1
The transfer load successfully sits on the hole which its
weight triggers the coil spring. Coil spring rotates the gear
system by a belt. Rotary rope climber raises the platform to
the top while the rubber/friction lace lining prevent the
platform from sliding down
Device B Alternative 2
The transfer load falls to the crater and it presses onto the
lower plate, causing the tip to fall off from the rectangular
hole of upper plate. The loop hang that was originally
hanged on the tip falls and unloads the whole platform.
Originally, with the weight attached to the platform, it is
impossible for the helium balloon to raise the load up.
However after unloading the weight, the platform will
become lighter in weight and able to lift the platform to the
top gradually and stop at the stopper.

You might also like