Lab Report Reaction (Temperature)

TECHNICAL/EXECUTIVE REPORT : CHEMICAL ENGINEERING
CHE244:Introduction To
Lab No. : 4 Subject : Chemical Reaction
Experiment Effect of Temperature on The Reaction

Mark :
Title : in a TFR
Date:
100
Participant Course : EH 110 Semester : 3 Group: C
*Please cancel which
Signatur
is not necessary. No. Name Matrix No.
e
1 Muhammad Alim Adha Bin Makhtar 2015867798
2 Noor Izzah Nadhirah bt Muhamad Zahidi 2015863386
3 Amirul Fahd Bin Yusseri 2015848158
4 Mohamad Azizul Bin Mohamad Azmi 2015844836
5 Nurul Najihah Binti Fadzin 2015861238
Instructor
1. Madam Zarina Binti Omar
2.
Objective :
1. To determine the effect of temperature on the conversion in a TFR.
Abstract :
In the experiment, we had to determine the effect temperature on the conversion in a TFR. Firstly,
performed the general start-up procedures. Next, adjusted the valves to be about 0.15 l/min at flow meter
1 and flow meter 2.Both flow rate should be the same. Then, we recorded the flow rates. The setpoint is
at 40ºC. To ensure the reactor has reached the steady,we started monitoring the conductivity values and
temperature until they do not change over time. Then, start recording the inlet and outlet steady state
conductivity values and the water jacket temperature. By using different setpoint by increasing 5 oC the
temperature such as 45ºC, 50ºC,55ºC. Both solution have to be maintained at 0.15 l/min. From the
calibration curve, find the concentration of NaOH exiting the reactor the extent of conversion.
Introduction: In the most of industrial chemical processes,the reactor is the key equipment in
which raw materials are changed into desired products.The design and operation of
chemical reactor are important in order to make the process success.Understanding
on how the reactor works is necessary for the proper control of a reaction
system.basically there are two main groups of reactors,batch reactors and
continuous flow reactors.Tubular flow reactor has been designed for
students’experiments on chemical reactions in liquid phase under isothermal and
adiabatic conditions.the unit comes complete with a jacketed plug flow
reactor,individual reactant feed tank and pumps,temperature sensors and
conductivity measuring sensor.
Water Jacket Steady-state Flow Rate (l/min)

Data/Results: Temperature Conductivity Value
(K) (mS/cm)
Inlet Outlet
313 11.6 4.6
0.15
318 11.5 4.3
323 11.4 3.8
328 11.0 3.2
Conversion Solution Mixtures (ml) Concentration Conduc

(%) 0.1M NaOH 0.1M H2O NaOH tiv-ity
Na(Ac)
0% 100 - 100 0.0500 10.2
25% 75 25 100 0.0375 7.9
50% 50 50 100 0.0250 6.2
75% 25 75 100 0.0125 5.1
100% - 100 100 0.0000 3.8
Conversion Solution Mixtures (ml) Concentration Conduc
Calculation: (%) 0.1M NaOH 0.1M H2O NaOH tiv-ity
Na(Ac)
0% 100 - 100 0.0500 10.2
25% 75 25 100 0.0375 7.9
50% 50 50 100 0.0250 6.2
75% 25 75 100 0.0125 5.1
100% - 100 100 0.0000 3.8
Calculation for conversion, based on outlet conductivity:
At 313 K : At 318 K :
= 84.62% = 90.38%
At 323 K : At 328 K :
Conductivity= 3.8, 3.2<3.8

Thus conversion is 100% Thus conversion is 100%
Temperature (K) Outlet Conductivity Conversion (%)

(mS/cm)
313 4.6 84.62
318 4.3 90.38

323 3.8 100
328 3.2 100
Based on the table above :

Discussion:
The graph shows that conversion is linearly increase to the reaction

temperature.The conversion increase as the reaction temperature increases but in
temperature 323 K to 328 K the conversion constant. Then, based on calculation we
can conclude that reaction of temperature will decrease the conductivity of the
sodium hydroxide, NaOH.
Conclusion: Reaction of temperature is linearly increase to the conversion of NaOH in a Tubular

Flow Reactor (TFR).
References: 1. Elements of Chemical Engineering Reaction Fogler Fourth Edition

2. https://www.scribd.com/doc/143020478/L9-Tubular-Flow-Reactor
3. http://www.slideshare.net/NurulAin45/chemical-reaction-engineering-
28330576
4. http://documents.mx/documents/lab-pfr.html
5. http://www.docfoc.com/lab-report-cre-tfr
Authorize Person Date Signature/Stamp

Submission
Allocated Marks for Technical/Executive report
Criteria Full Marks

Abstract 10
Objective 10
Data/Results/Calculation 20
Discussion 30
Conclusion 10
References 10
Overall structure/organization and Quality 10
TOTAL 100
Comments:

Lab Report Reaction (Temperature)

Uploaded by

Lab Report Reaction (Temperature)

Uploaded by

TECHNICAL/EXECUTIVE REPORT : CHEMICAL ENGINEERING

Experiment Effect of Temperature on The Reaction

Water Jacket Steady-state Flow Rate (l/min)

Conversion Solution Mixtures (ml) Concentration Conduc

Calculation for conversion, based on outlet conductivity:

Conductivity= 3.8, 3.2<3.8

Temperature (K) Outlet Conductivity Conversion (%)

318 4.3 90.38

328 3.2 100

Based on the table above :

The graph shows that conversion is linearly increase to the reaction

Conclusion: Reaction of temperature is linearly increase to the conversion of NaOH in a Tubular

References: 1. Elements of Chemical Engineering Reaction Fogler Fourth Edition

Authorize Person Date Signature/Stamp

Criteria Full Marks

You might also like