Scribd
Upload
246 views1 page

Colant Temp-1

The document provides diagnostic information for a fault with the engine coolant temperature sensor in a Volvo EC290B LC excavator. It describes 3 fault modes detected by the engine control unit where the coolant temperature is too high, the sensor voltage is too low, or the voltage is too high. For each fault mode, it lists the detection conditions, symptoms, and possible causes. The recommended action is to check fault code 128 PID110 in guided diagnostics.

Uploaded by

Naing Min Htun
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
Download as pdf or txt
246 views1 page

Colant Temp-1

The document provides diagnostic information for a fault with the engine coolant temperature sensor in a Volvo EC290B LC excavator. It describes 3 fault modes detected by the engine control unit where the coolant temperature is too high, the sensor voltage is too low, or the voltage is too high. For each fault mode, it lists the detection conditions, symptoms, and possible causes. The recommended action is to check fault code 128 PID110 in guided diagnostics.

Uploaded by

Naing Min Htun
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
Download as pdf or txt
Download as pdf or txt
You are on page 1/ 1

Volvo Guided Diagnostics

Date: Information Type:


8/5/2011 1 Diagnostics Fault Codes 128: Engine ECU 110: Engine coolant temperature
Profile:
EXC, EC290B LC (Volvo) [GB] EXC, EC290B LC (Volvo) [GB] EXC, EC290B LC (Volvo) [GB] EXC, EC290B LC (Volvo) [GB]

MID128 Engine ECU;PID110 Engine coolant temperature(128 PID110)


128 PID110

Reference 260 Cooling system, description

Fault mode diagnosis

Fault mode Detection conditions:The engine control unit (E-ECU) registers: Coolant temperature
FMI 0 higher than 100ºC
Symptom: Possible causes:

 Red central warning  Low coolant level


 Buzzer sounds continuously  Clogged radiator
 Error message screen  Wrong coolant
 Extreme running conditions

Action 3021 128 PID110

Fault mode Detection conditions:The engine control unit (E-ECU) registers: that the voltage is below
FMI 4 0.12 V(EB27)
Symptom: Possible causes:

 Red central warning  Signal line short circuited to lower


 Buzzer sounds continuously voltage
 Error message screen  Defective sensor

Action 3021 128 PID110

Fault mode Detection conditions:The engine control unit (E-ECU) registers: that the voltage is above
(missing infotext) 4.92 V(EB27)
Symptom: Possible causes:

 Red central warning  Signal line short-circuited to


 Buzzer sounds continuously higher voltage
 Error message screen  open circuit
 Defective sensor

Action 3021 128 PID110

Guided Diagnostics

You might also like