3.1 Assessing Your Organisation - The Energy Management Matrix
3.1 Assessing Your Organisation - The Energy Management Matrix
This module provides a means of assessing the capacity of the organisation relative to these
six functions, and of action planning to develop capacity. The Energy Management Matrix
and other subsidiary assessment matrices developed in the UK are used as a basis for
assessment and planning.
The Best Practice Program in the UK has produced a matrix that is a very useful tool to carry
out this assessment. This matrix has been devised to:
♦ help you identity and describe the current priority attached to different aspects of
energy management in your organisation
♦ concentrate on those columns where you can make the most progress
♦ identify opportunities for improvement and decide how these can be exploited
♦ involve others, both senior managers and end users, in this process.
At Level 1, there is some commitment to addressing energy use, even though there
is no explicit policy. Awareness of energy efficiency as a corporate concern is
created informally, but monitoring of energy use is done only to a very limited extent.
At Level 2, senior managers accept the importance of energy management, but there
is little active support for energy management functions. Some responsibility for
energy management has been allocated, usually within a technical department, and
there may be some communication on these matters with other departments. The
main weakness of the organisation at this level is the lack of commitment from top
management.
Only by developing energy management evenly will you be sure of getting the most
out of your investment.
♦ assessing the quality and level of support which you are being given
Step 1: Make a photocopy of the matrix from Figure 3.1. Consider each column, one
at a time. Mark the place in each column that best describes where you think you are
currently located. Place your mark in the appropriate cell or between cells if you think
this is more accurate.
Step 2: Then join up your marks across the columns to produce a graph line. This is
your Organisational Profile. It will give you an overall indication of how balanced
energy management is in your organisation.
Don’t worry if the Profile is uneven. This is the case in most organisations. The
peaks represent where your current effort is most sophisticated. The troughs indicate
where you are least advanced.
Step 3: Make a second photocopy of the matrix and ask your line manager to repeat
the process, marking it up in the same way.
Step 4: Compare your Organisational Profiles. Where they disagree, discuss your
assessments to see if you can reach an agreed compromise position. If you can
agree on the Profile, draw it on a third photocopy. If you can’t agree, draw both
Profiles on and label them as your separate views. Do not regard failure to agree as
a problem. It simply reflects your different viewpoints and understanding.
Even if you agree, you may find it instructive to ask others to fill in the matrix,
particularly if they are involved with the management of energy consuming systems.
Their Profiles will tell you how others in your organisation see energy management.
This can help you obtain a broader perspective on the issue in terms of organisational
strengths and weaknesses. Where you have collected this information, include their
labelled Profiles on the third photocopy.
Step 5: Working on your own, decide which columns contain issues that are most
important in your own particular circumstances. Choose two columns where you
would most like to see a change or improvement. Then list what you see as the five
main obstacles impeding your progress to the next level up in each of these columns.
Then identify three key opportunities for improving your performance.
It will not always be the columns with the lowest score that warrant immediate
attention. If the obstacles you identify seem insurmountable from where you stand, or
if there are no obvious opportunities for improvement, then you may be better off
investing your limited time and attention elsewhere. Remember too that others in
your organisation’s hierarchy or located in other departments, may be able to remove
obstacles or to create opportunities which are simply not open to you. Try to identify
where this is so and what they need to do if they are to help.
Step 7: Again compare your lists. If you disagree, try to reach a consensus. If you
can’t, simply amalgamate your lists of obstacles and opportunities.
Step 8: Pass a photocopy of the matrix to your senior managers and ask them to
repeat the exercises done by you and your line manager. Ask them to return the
results to you for collation. Include their Organisational Profiles on the third
photocopy.
Step 9: Write up the collated results in a report to your senior managers. Include all
the labelled Organisational Profiles on the matrix and the collated lists of obstacles
and opportunities. End with a set of recommendations proposing how identified
obstacles can be overcome and how opportunities can be exploited. Where you are
unable to do this, table a series of questions for senior managers asking what they
believe needs to be done to improve the present situation.
Step 10: Use the dialogue started by these exercises to construct, in negotiation with
your senior managers, an Action Plan for improving energy management over the
next twelve months. Include some interim milestones and specify:
♦ who is responsible for taking each of the actions listed,
♦ and how progress is to be measured at the end of the period.
One possible method for measuring progress is to use the Energy Management
Matrix at the end of the period to identify how the Organisational Profile has changed.
Focus on
low scores
Three cases from the UK illustrate the point. In Good Practice Case Study 341:
Energy Management – Awareness and Motivation, we see a loose correlation
between Digital Equipment Corporation’s improved rating on the Energy Management
Matrix and a verified reduction in electricity consumption of 12.5%. Similarly, The
Sears Group (ref. Good Practice Case Study 327: Energy Management – staff
awareness and motivation) and British Telecommunications (ref. Good Practice
Case Study 324: Energy Management – staff awareness) undertook
comprehensive training and communication activities that led to improvements in their
EM Matrix ratings while reporting significant savings. Table 3.1 below gives details of
the ratings and improvements.
Investment
Motivation
% Savings
Marketing
Systems
Energy
Rating
Policy
The Sears Group Before 0.5 1.0 3.0 2.0 2.0 2.0 10.5
11.5 7.2
GPCS 327 After 3.5 3.5 4.0 3.5 4.0 3.5 22.0
British Telecom Before 1.0 2.0 1.0 1.0 1.0 3.0 9.0
10.0 3.0
GPCS 324 After 4.0 2.0 3.0 3.0 4.0 3.0 19.0
Digital Equipment Before 1.5 1.0 0.5 1.0 0.0 1.0 5.0
13.0 12.5
Corporation GPCS 341 After 3.5 3.0 3.0 4.0 3.5 1.0 18.0
14.0
10.0
8.0
6.0
4.0
2.0
0.0
9.0 10.0 11.0 12.0 13.0 14.0
Net Change in Energy Management Matrix Rating
Figure 3.5 plotted from the data of Table 3.1 clearly demonstrates the correlation
between energy savings and the organisation’s EM Matrix rating.
Critical success factors for Woodbridge related to the Energy Management Matrix included:
♦ Energy policy: there was top management commitment, expressed through the
company’s Health, Safety and Environmental (HSE) Policy with the statement
“reduction of energy consumption and the resultant release of greenhouse gases”;
♦ Organizing: energy management was fully integrated into the organizational structure
through its HSE business practices and ISO14001; plants developed standard
operating procedures to incorporate energy management practices;
♦ Skills and Knowledge: employees were empowered to act on energy management
priorities, educated and trained to develop the knowledge and skills needed to operate
plant systems at optimum efficiency;
♦ Information Systems: an Energy Reduction Management System was implemented
to routinely collect energy use data, analyze it, set annual reduction targets, and report
systematically throughout the organization;
♦ Marketing and Communicating: campaigns employing posters, in-house
publications, and other means heightened the awareness of all employees regarding
the company’s energy management goals, processes and achievements.
The conclusions that the company drew from its experience in getting started on energy
management were:
♦ Identify “Low Hanging Fruit” Opportunities, that require limited capital spending
♦ Work on changing behaviours
♦ Report Baseline Data and Projects
♦ Share Information Amongst Various Sites
♦ Get Everyone Involved
♦ Use External Resources – International best practice, Energy Websites (e.g. U.S.
DOE), Suppliers/Consultants
This is not to suggest that action planning is a simple process. To be effective, the tasks
must be feasible and clearly defined. The right people need to be mandated to carry out the
tasks.
Timing is critical; in a plant environment, the task must be scheduled around operational
constraints. For example, some tasks can only be done when the plant is down; others, such
as those related to data collection, can only be done when it is operating.
Resource planning is probably the most difficult part. It cannot be assumed that the people
required to do the job can be automatically deployed. If there are funding requirements, it
may be necessary to make a “business case” for the task (see Module 8).
In this Module, for convenience, we refer to the individual who drives the planning process as
the “energy manager”. As noted in earlier, not all companies choose to designate an “energy
manager”; however, it is essential that someone be charged with the responsibility of leading
the energy management agenda, even if that someone carries other responsibilities, such as
plant management, maintenance supervision, or whatever. In this module, then, where we
use the term “energy manager”, think of that individual who is the energy efficiency
“champion” or leader in your organisation.
The Worksheets that follow are provided as a basis for organising the plan. The general
principle that applies is that actions need to be taken to move upwards in the matrix, column
by column; one level of movement at a time is probably a reasonable objective.
The Modules that follow in this course address each of the organisational issues, and
therefore, each of the matrix columns in more detail. Planning is an iterative process; the
actions contemplated immediately following organisational assessment will probably be
adapted and refined as more is learned about each of these management issues.
Energy
Policy
Energy policy, action
plan and regular
review have
commitment of top
management as part
of a business &
environmental
strategy
“
Formal energy policy
but no active
commitment from
top management.
“
Unadopted energy
policy set by senior
manager or senior
departmental
manager.
“
An unwritten set of
guidelines.
“
No explicit policy.
Role/Responsibility Who
1. Managing distribution of energy
2. Defining energy policy
3. Capital equipment purchase
11. Reviewing energy usage and costs on an annual basis for the business
12. Ensuring that machinery and equipment is shut off when not being used
13. Reviewing capital expenditure plans for energy efficiency aspects
Organising
Energy management
fully integrated into
management
structure. Clear
delegation of
responsibility for
energy consumption.
“
Energy manager
accountable to
energy committee
representing all
users,
“
Energy manager in
post, reporting to ad-
hoc committee but
line management
and authority
unclear.
“
Energy management
the part-time
responsibility of
someone with only
limited authority or
influence.
“
No energy
management or any
formal delegation of
responsibility for
energy use.
“
Skills
& Knowledge
All energy users
receive specific
energy training
integrated into other
development
activities.
Workshops facilitate
a sharing of
knowledge.
“
Key energy users
receive regular and
specific training.
Brief awareness
training provided to
all energy users.
“
Key energy users
receive awareness
training, also
occasional system-
specific training.
“
Key employees
participate
occasionally in
awareness training.
Some information
passed informally to
energy users.
“
Energy users rely on
their existing
knowledge.
Information
Systems
Comprehensive
system sets targets,
monitors consumption,
identifies faults,
quantifies savings and
provides budget
tracking.
“
Monitoring and
targeting reports for
individual areas based
on sub-metering, but
savings not effectively
reported to user.
“
Monitoring and
targeting reports
based on supply meter
data. Energy unit has
ad-hoc involvement in
budget setting.
“
Cost reporting based
on invoice data.
Engineer compiles
reports for internal use
within technical
department.
“
No information
systems. No
accounting for energy
consumption.
Marketing &
Communicating
Communicating the
value of energy
efficiency and the
performance of
energy management
within the
organisation and
outside.
“
Programme of staff
awareness and
regular publicity
campaigns.
“
Some ad-hoc staff
awareness training.
“
Informal contacts
used to promote
energy efficiency.
“
No promotion of
energy efficiency.
Investment
Positive
discrimination in
favour of green
schemes with
detailed appraisal of
all new-build &
refurbishment
opportunities.
“
Same payback
criteria employed as
for all other
investments.
“
Investment using
short term pay back
criteria only.
“
Only low cost
measures taken.
“
No investment in
increasing energy
efficiency in the
plant.