Scribd
Upload
171 views3 pages

Connect As Below:: Serial Suite: ECU Plug

The document provides instructions for connecting a serial suite to an ECU plug and reading the ECU. The red wire of the serial suite should be connected to pin 1 (power), the black wire to pin 1 (ground), and the green wire to pin 1 (K line). A warning is given to not make the connection hole deeper than 3mm. To read the ECU, the boot pin should be connected to the serial suite's blue banana cable and a metal point pressed on the serial suite software button "Identify" until it shows "Ready".

Uploaded by

rumellemur59
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
Download as pdf or txt
171 views3 pages

Connect As Below:: Serial Suite: ECU Plug

The document provides instructions for connecting a serial suite to an ECU plug and reading the ECU. The red wire of the serial suite should be connected to pin 1 (power), the black wire to pin 1 (ground), and the green wire to pin 1 (K line). A warning is given to not make the connection hole deeper than 3mm. To read the ECU, the boot pin should be connected to the serial suite's blue banana cable and a metal point pressed on the serial suite software button "Identify" until it shows "Ready".

Uploaded by

rumellemur59
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
Download as pdf or txt
Download as pdf or txt
You are on page 1/ 3

Connect as below:

Serial Suite: ECU Plug:

Red to 1 Pins Red (Power Supply +12 Volt)


Black to 1 Pins Black (Ground)
Green to 1 Pin Green (K Line)

Piasiniengineering info@piasinienginnering.it – http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298
WARNING:
Make the hole NO deeper
than 3mm !

Piasiniengineering info@piasinienginnering.it – http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298
How to connect the flat cable for READING

The boot pin you have to connect it to Serial Suite’s blue banana through the
appropriate cable and the metal point. Hold connect the metal point, press on the
SerialSuite software button “Identify” and wait until you see on the software’s
windows “Ready”, then you can remove the metal point and you are able to READ and
WRITE the Ecu.

Piasiniengineering info@piasinienginnering.it – http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298

You might also like