Module 3 Introduction To Feedback and Control System
Module 3 Introduction To Feedback and Control System
output. The following figure shows the simple block diagram of a control system.
Control action is independent of the desired Control action is dependent of the desired
output. output.
These are also called as non-feedback control These are also called as feedback control
systems. systems.
Inaccurate. Accurate.
Control Systems - Feedback
Feedback plays an important role in order to improve the performance of the control
systems. In this chapter, let us discuss the types of feedback & effects of feedback.
Types of Feedback
There are two types of feedback −
Positive feedback
Negative feedback
Positive Feedback
The positive feedback adds the reference input, R(s) and feedback output. The
following figure shows the block diagram of positive feedback control system.
The concept of transfer function will be discussed in later chapters. For the time being,
consider the transfer function of positive feedback control system is,
Where,
T is the transfer function or overall gain of positive feedback control system.
G is the open loop gain, which is function of frequency.
H is the gain of feedback path, which is function of frequency.
Negative Feedback
Negative feedback reduces the error between the reference input, R(s) and system
output. The following figure shows the block diagram of the negative feedback
control system.
Where,
T is the transfer function or overall gain of negative feedback control system.
G is the open loop gain, which is function of frequency.
H is the gain of feedback path, which is function of frequency.
The derivation of the above transfer function is present in later chapters.
Effects of Feedback
Effect of Feedback on Overall Gain
'G' and 'H' are functions of frequency. So, the feedback will increase the overall gain of
the system in one frequency range and decrease in the other frequency range.
.
Effect of Feedback on Stability
A system is said to be stable, if its output is under control. Otherwise, it is said to
be unstable.
In Equation 2, if the denominator value is zero (i.e., GH = -1), then the output of
the control system will be infinite. So, the control system becomes unstable.