Lab Report 02 - Implement of 2D Drawing
Uploaded by
Joy PalLab Report 02 - Implement of 2D Drawing
Uploaded by
Joy PalGreen University of Bangladesh
Department of Computer Science and Engineering (CSE)
Faculty of Sciences and Engineering
Semester: (Fall, Year:2021), B.Sc. in CSE (Day)
LAB REPORT NO #2
Course Title: Engineering Drawing
Course Code: CSE 208 Section: 203DA
Lab Experiment Name: Implementation of 2D Drawing.
Student Details
Name ID
1. Joy Pal 201002418
Submission Date : 12.12.2021
Course Teacher’s Name : Mr. Montaser Abdul Quader
[For Teachers use only: Don’t Write Anything inside this box]
Lab Report Status
Marks: ………………………………… Signature:.....................
Comments:.............................................. Date:..............................
1. TITLE OF THE LAB EXPERIMENT
Implementation of 2D Drawing.
2. OBJECTIVES
To learn 2D drawing using line, circle and polygon.
To implement the advance knowledge for 2D drawing.
3. DESIGN AND IMPLEMENTATION
Drawing 01 :
i. Specify and draw the reference point and draw the line.
ii. Draw the polygon of 6 side and trim the unnecessary line.
iii. Draw a circle with diagram 4 and trim the unnecessary line
iv. Draw a circles with radius 1.6
v. Again draw a circle ( tan, tan, radius) R-3.
Output
Drawing 02 :
1. Specify the points and draw the lines.
2. Draw two circle with diameter
3. Draw a circle with radius 60
4. Draw a circle with diameter 20 and trim the unnecessary line.
5. Draw two circle with diameter 19, 44.
6. Draw a circle with radius (tan, tan, radius) 25 and trim the
unnecessary line.
7. Draw 4 circle with diameter 14.
8. Again draw 4 circle at the same point with radius 13.
Output
