Intro - Data Communication Networks

DATA COMMUNICATION
NETWORKS
1151EC111
DEFINITION
Data Communication is the

exchange of Information from one
entity to the other using a
Transmission Medium
Definition (Modified)
Data Communication is the

exchange
of data (in the form of 0’s and 1’s)
between two devices (computers) via
some form of the transmission
medium.
LOCAL and REMOTE Communication
LOCAL :
Communicating devices are present
in the same building or a similarly
restricted geographical area
LOCAL and REMOTE Communication
REMOTE :
Communicating devices are present
farther apart
Data Communication System
• Data Communication to occur

the communicating devices must
be a part of a system made up of
some specific kind of hardware
and software.
Effectiveness of Data Comm. System
Effectiveness depends upon the fundamental
characteristics:
• Delivery
• Accuracy
• Timeliness
• Jitter
Components of a Simple Data
Communication System
Components of a Data Comm. Sys.
Data communication system has 5 components:

• Message
• Sender
• Receiver
• Medium
• Protocol
Transmission Modes - Simplex
Data representation:
Text : bits called as codes.
ASCII(7 bits), Extended ASCII (8 bits)
Unicode : 16 bits; used to represent different languages
32-bit Numbers, Image, Audio, Video
Data Flow: Simplex [Unidirectional]
Half-duplex
Half-duplex mode: Each station can both transmit and receive,
but not at the same time
The entire capacity of a channel is taken over by whichever of
the two devices is transmitting at the time.
Full-duplex
Both stations can transmit and receive simultaneously

Signals going in either direction share the capacity of the link.
Link might have two lines or a channel is divided between signals
travelling in both directions.
Computer Networks
Network: set of devices connected by

communication links.
Distributed Processing: Task is divided

among multiple computers.
Physical connection
Point-to-point:
 Provides a dedicated link between two devices.
 Entire capacity of the link is used.
Multipoint Connection
• More than two specific devices share a single link.
• Spatially shared: Several devices can use the link
simultaneously
• Timeshare: Users must take turns.
Categories of Topology
Physical Topology
• Refers to the way in which a network is laid out physically.
• Two or more devices connect to a link.
• Two or more links form a topology.
• Topology of a network is the geometric representation of relationship
of all the links and linking devices (nodes) to one another.
Fully connected mesh topology
Every device has a dedicated point-to-point link to every
other device.
Dedicated means that the link carries traffic only between the two devices it
connects.
Adv: Guaranteed load, robust, privacy or security, fault identification and fault
isolation is easier.
Disadv: amount of cabling, I/O ports, installation is difficult, more wiring w.r.t
space, expensive hardware.
.
Star topology
Each device has a dedicated pt-to-pt link only
to a central controller [Hub]
No direct connection or traffic
Adv: less expensive, one link and one I/O port, easy to install
and reconfigure, less cabling (but more than bus or ring),
node failure will not affect others, fault identification is
easier
Disadv: Single point of failure
Bus topology
 Multipoint: One cable acts as a backbone to link all the
devices in a network.
 Drop line: a connection running between the device and
main cable.
 Tap: a connector that either splices into the main cable or
punctures the sheathing of the cable to create a contact
with the metallic core.
 Signal degrades due to energy being transformed into
heat. So, there is limitation on the number of taps allowed. Adv: easy
 to install, less cabling.
 Disadv: Limit on number of taps and the distance
between taps, difficult to identify fault, signal
degradation, modification is difficult.
Ring topology
• Each device has a dedicated pt-to-pt connection only with the
devices on either side of it.
• Each device incorporates a repeater.
• When a device receives a signal intended for another device, its repeater
regenerates the bits and passes them along.
• Adv: Easy to install, fault isolation is easier, Signal circulates at all times
(alarm alerts the problem and its location).
• Disadv: Unidirectional traffic, in a simple ring; break in the ring can
disable entire network.
Categories of Networks
 Size
 Ownership
 Distance it covers
 Physical architecture
LAN
 Privately owned
 Links devices in single office, building or campus.
 Limited to few kilometres.
 Sharing of resources: Hardware or data.
 Use a single transmission media.
 Topology: Ring, bus, star.
LAN (Continued)
MAN
 Extend over an entire city.
 Owned and operated by a private company
 Service provider
 Public
company.
WAN
Provides long-transmission of data, voice, image and video
information over large geographic areas that may comprise a
country, a continent or even the whole world.
WAN that is wholly owned and used by a single

company is often referred to as an enterprise network.
The Internet
The Internet Today

National Service Providers (NSPs)
Backbone networks, maintained by specialized companies
Network Access Points (NAP)

Switching stations that provide connectivity between
the end users and backbone networks.
Regional and local Internet Service Providers (ISP).

Internet today
Protocols and Standards
Protocols: set of rules that governs data
communications.
A protocol defines what is communicated, how
it is
communicated and when it is communicated.
Syntax: it refers to the structure or format of
data.
Semantics: it refers to the meaning of each
section of bits
Timing: It refers to two characteristics; when and how
much to send.
Standards: Provide guidelines.
Standard Organizations
 International Organization for Standardization (ISO)

 International
Telecommunication Union-
Telecommunication Standards (ITU-T)
 American National Standards Institute (ANSI)
 Institute of Electrical and Electronics Engineers (IEEE)
 Electronic Industries Association (EIA)
 International Engineering Task Force (IETF)
Transmission Media
Medium Speed
Cost
Twisted Wire
300bps-100Mbps Low
Microwave
256Kbps-100Mbps Low
Coaxial Cable
56Kbps-200Mbps Low
Fiber Optic
Cable 500Kbps-10Gbps High
A Complex Data Comm. System
EXAMPLE – Electronic Mail
References
• https://youtu.be/vv4y_uOneC0
• https://www.youtube.com/watch?v=FLBx69iWUGg
• https://www.youtube.com/watch?v=x7CNq4wWgI8

Intro - Data Communication Networks

Uploaded by

Intro - Data Communication Networks

Uploaded by

DATA COMMUNICATION

Data Communication is the

Data Communication is the

• Data Communication to occur

Data communication system has 5 components:

Both stations can transmit and receive simultaneously

Network: set of devices connected by

Distributed Processing: Task is divided

WAN that is wholly owned and used by a single

The Internet Today

Network Access Points (NAP)

Regional and local Internet Service Providers (ISP).

 International Organization for Standardization (ISO)

You might also like