Scribd
Upload
42 views

Implementing Quality of Service (Qos) Module 4 Lesson 7 Review

Uploaded by

Amine Inptic
Copyright
© © All Rights Reserved
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
42 views

Implementing Quality of Service (Qos) Module 4 Lesson 7 Review

Uploaded by

Amine Inptic
Copyright
© © All Rights Reserved
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 11

Implementing Quality of Service

(QoS)

Module 4 Lesson 7 Review

http://www.INE.com
Question 1
From the following list, identify the valid match command which can be issued
in class-map configuration mode:

a. match all
b. match output-interface ethernet 0/0
c. match protocol telnet
d. match access-list 101

Copyright © 2010 Internetwork Expert, Inc


www.INE.com
Question 1 - Answer
From the following list, identify the valid match command which can be issued
in class-map configuration mode:

a. match all
b. match output-interface ethernet 0/0
c. match protocol telnet
d. match access-list 101

Copyright © 2010 Internetwork Expert, Inc


www.INE.com
Question 2
A best practice for QoS configuration is to classify traffic as close to the source
as possible. Traffic classification can be performed using which two of the
following approaches? (Choose 2)

a. Classification based on the amount of time a packet has been waiting in a


queue
b. Classification using Network Based Application Recognition (NBAR)
c. Classification using access control lists (ACLs)
d. Classification based on a tunnel encapsulation type

Copyright © 2010 Internetwork Expert, Inc


www.INE.com
Question 2 - Answer
A best practice for QoS configuration is to classify traffic as close to the source
as possible. Traffic classification can be performed using which two of the
following approaches? (Choose 2)

a. Classification based on the amount of time a packet has been waiting in a


queue
b. Classification using Network Based Application Recognition (NBAR)
c. Classification using access control lists (ACLs)
d. Classification based on a tunnel encapsulation type

Copyright © 2010 Internetwork Expert, Inc


www.INE.com
Question 3
When sending traffic across a service provider network, using BGP as the
exterior gateway routing protocol, the service provider can use BGP
attributes (e.g. a community string or an autonomous system path) to cause
edge routers to mark traffic with IP Precedence or QoS group values.
Identify this QoS mechanism.

a. CEF
b. QBBP
c. MIB
d. Pre-Classify

Copyright © 2010 Internetwork Expert, Inc


www.INE.com
Question 3 - Answer
When sending traffic across a service provider network, using BGP as the
exterior gateway routing protocol, the service provider can use BGP
attributes (e.g. a community string or an autonomous system path) to cause
edge routers to mark traffic with IP Precedence or QoS group values.
Identify this QoS mechanism.

a. CEF
b. QBBP
c. MIB
d. Pre-Classify

Copyright © 2010 Internetwork Expert, Inc


www.INE.com
Question 4
A user’s PC is connected to the PC port of a Cisco IP Phone. The Cisco IP
Phone is then connected into a Cisco Catalyst 2950 switch interface,
FastEthernet 0/2. While you do not want to trust CoS markings coming from
the PC, you do want the PC’s traffic marked with a CoS value of 2. Which of
the following interface configuration mode command will cause the PC’s
frames to be marked with a CoS of 2?

a. switchport extended trust cos 2


b. switchport priority trust cos 2
c. switchport trust extend cos 2
d. switchport priority extend cos 2

Copyright © 2010 Internetwork Expert, Inc


www.INE.com
Question 4 - Answer
A user’s PC is connected to the PC port of a Cisco IP Phone. The Cisco IP
Phone is then connected into a Cisco Catalyst 2950 switch interface,
FastEthernet 0/2. While you do not want to trust CoS markings coming from
the PC, you do want the PC’s traffic marked with a CoS value of 2. Which of
the following interface configuration mode command will cause the PC’s
frames to be marked with a CoS of 2?

a. switchport extended trust cos 2


b. switchport priority trust cos 2
c. switchport trust extend cos 2
d. switchport priority extend cos 2

Copyright © 2010 Internetwork Expert, Inc


www.INE.com
Question 5
You are configuring a Cisco Catalyst 2950 switch port to trust CoS markings if,
and only if, the marking originated from a Cisco IP Phone. In an attempt to
perform this configuration, you enter the mls qos trust device cisco-
phone command. However, your configuration does not seem to be working
properly. Why is the switch not trusting CoS markings coming from an
attached Cisco IP Phone?
 
a. A Cisco Catalyst 3550 switch supports the mls qos trust device cisco-
phone command, but the Cisco Catalyst 2950 does not support this
command.
b. The mls qos trust cos command is missing.
c. The mls qos trust extend command is missing.
d. The mls qos cos 5 command is missing.

Copyright © 2010 Internetwork Expert, Inc


www.INE.com
Question 5 - Answer
You are configuring a Cisco Catalyst 2950 switch port to trust CoS markings if,
and only if, the marking originated from a Cisco IP Phone. In an attempt to
perform this configuration, you enter the mls qos trust device cisco-
phone command. However, your configuration does not seem to be working
properly. Why is the switch not trusting CoS markings coming from an
attached Cisco IP Phone?
 
a. A Cisco Catalyst 3550 switch supports the mls qos trust device cisco-
phone command, but the Cisco Catalyst 2950 does not support this
command.
b. The mls qos trust cos command is missing.
c. The mls qos trust extend command is missing.
d. The mls qos cos 5 command is missing.

Copyright © 2010 Internetwork Expert, Inc


www.INE.com

You might also like